Case-IH 9130 or International Harvester 7288?
Which should you choose?
On performance, every comparable figure that differs favours the Case-IH 9130: power at the PTO shaft. On features, the International Harvester 7288 is ahead on forward gears.
- The Case-IH 9130 suits PTO-driven implements (mowers, balers, pumps) better on this data: 11% (13.9 kW / 18.6 hp) more power at the PTO shaft.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 9130 | 7288 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 142.6 kW (191.2 hp)Traktorenlexikon, “Case-IH 9130” | 128.7 kW (172.6 hp)Traktorenlexikon, “IHC 7288” | AheadThe Case-IH 9130 has 11% more power at the PTO (13.9 kW / 18.6 hp) than the International Harvester 7288 (both power at the PTO, claimed). |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 9130 and the 7288. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 9130 and the 7288. |
| Which pumps more oil for implements? | 107.1 L/min (28.3 gpm)Traktorenlexikon, “Case-IH 9130” | 106.0 L/min (28.0 gpm)Traktorenlexikon, “IHC 7288” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | 6,067 kg (13,375 lb)Traktorenlexikon, “Case-IH 9130” | — | No figureNo call on three-point lift: no figure on record for the 7288. |
| Which is heavier, for traction? | 9,560 kg (21,076 lb)Traktorenlexikon, “Case-IH 9130” | 8,958 kg (19,749 lb)Traktorenlexikon, “IHC 7288” | EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 9130 and the 7288. |
| Which has the wider choice of gears? | 12Traktorenlexikon, “Case-IH 9130” | 18Traktorenlexikon, “IHC 7288” | AheadThe International Harvester 7288 has 50% more forward gears (6 gears) than the Case-IH 9130 (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 9130 and the 7288. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Case-IH 9130” | 30 km/h (18.6 mph)Traktorenlexikon, “IHC 7288” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 1000 rpmTraktorenlexikon, “Case-IH 9130” | 1000 rpmTraktorenlexikon, “IHC 7288” | EvenEven on PTO speeds: the same speeds (1000 rpm). |
| Which PTO runs independently of the ground drive? | — | — | No figureNo call on PTO independence: not stated for the 9130 and the 7288. |
| Which drives on both axles? | 4WDTraktorenlexikon, “Case-IH 9130” | 4WDTraktorenlexikon, “IHC 7288” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1987–1990 | 1985 | EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Case-IH 9130 has 11% more power at the PTO (13.9 kW / 18.6 hp) than the International Harvester 7288 (both power at the PTO, claimed).
- The International Harvester 7288 has 50% more forward gears (6 gears) than the Case-IH 9130 (both forward gears, as stated by the source).
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (1000 rpm).
- Even on drive: every machine is available with four-wheel drive.
- Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources