6 material differences · fewer than 12
Tractor oneCase-IH 845 XL (A)1990–1996No measured PTO figureTractor twoFiat 80-88/80-88 DT1989–1993No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
6 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 845 XL (A) | 80-88/80-88 DT | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 78.9 hp | 78.9 hp | — |
| Engine declared | IH D-268 | — | — |
| Displacement declared | 4.39 L | — | — |
| Maximum torque declared | 218 lb·ft · 296 N·m | 197 lb·ft · 267 N·m | +11% 845 XL (A) |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 23.6 mph · 38 km/h | +27% 80-88/80-88 DT |
| Hydraulics & hitch | |||
| Pump flow declared | 8.6 gpm · 32.6 L/min | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,069 lb · 3,660 kg | 7,562 lb · 3,430 kg | +7% 845 XL (A) |
| Maximum permissible mass declared | 12,787 lb · 5,800 kg | — | — |
| Wheelbase declared | 94.1 in · 2,390 mm | — | — |
| Length declared | 144.9 in · 3,680 mm | 144.9 in · 3,680 mm | — |
| Width declared | 80.7–88.6 in · 2,050–2,250 mm | 86.6 in · 2,200 mm | differs |
| Ground clearance declared | 19.1 in · 484 mm | 16.9 in · 430 mm | +13% 845 XL (A) |
| Turning radius, braked declared | 12.6 ft · 3.85 m | — | — |
| Fuel tank declared | 112.0 qt · 106.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 845 XL (A) sources
- Source: Traktorenlexikon, “Case-IH 845XL”
Fiat 80-88/80-88 DT sources
- Source: Traktorenlexikon, “Fiatagri 80-88/80-88 DT”