11 material differences · fewer than 12
Tractor oneCase-IH 5220 (DT)1989–1997No measured PTO figureTractor twoSteyr 9094 a1993–1995No measured PTO figure
Which should you choose?
Read our verdict on the 5220 (DT) and the 9094 a → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 5220 (DT) | 9094 a | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.7 hp | 92.8 hp | — |
| Engine declared | CUMMINS NCE 4 T-390 | Steyr-MWM WD 401.85 | differs |
| Displacement declared | 3.92 L | 4.16 L | +6% 9094 a |
| Maximum torque declared | 237 lb·ft · 321 N·m | 260 lb·ft · 353 N·m | +10% 9094 a |
| Transmission | |||
| Top speed declared | 15.5–24.9 mph · 25–40 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | — | Dry double clutch with pedal-operated driving clutch and hand lever-operated PTO clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Open centre | — |
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 19.6 gpm · 74.3 L/min | 14.1 gpm · 53.3 L/min | +39% 5220 (DT) |
| Pressure declared | 3,191 psi · 220 bar | 3,481 psi · 240 bar | +9% 9094 a |
| Rear PTO speeds declared | 635/1000 rpm | 390/540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,818 lb · 4,000 kg | 8,642 lb · 3,920 kg | — |
| Maximum permissible mass declared | 16,535 lb · 7,500 kg | 14,330 lb · 6,500 kg | +15% 5220 (DT) |
| Wheelbase declared | 107.5 in · 2,730 mm | 97.5 in · 2,477 mm | +10% 5220 (DT) |
| Length declared | 163.0 in · 4,140 mm | 165.2 in · 4,195 mm | — |
| Width declared | 79.7 in · 2,025 mm | 81.2 in · 2,063 mm | — |
| Ground clearance declared | 22.1 in · 561 mm | 17.7 in · 450 mm | +25% 5220 (DT) |
| Turning radius, braked declared | — | 15.7 ft · 4.80 m | — |
| Fuel tank declared | 179.6 qt · 170.0 L | 105.7 qt · 100.0 L | +70% 5220 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 5220 (DT) sources
- Source: Traktorenlexikon, “Case-IH 5220”
Steyr 9094 a sources
- Source: Traktorenlexikon, “Steyr 9094”