12 material differences
Tractor oneCase-IH 5220 (DT)1989–1997No measured PTO figureTractor twoSAME Panther 95 (DT)1979–1981No measured PTO figure
Which should you choose?
Read our verdict on the 5220 (DT) and the Panther 95 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 5220 (DT) | Panther 95 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 92.7 hp | 92.7 hp | — |
| Engine declared | CUMMINS NCE 4 T-390 | SAME DA 1055 P | differs |
| Displacement declared | 3.92 L | 5.19 L | +32% Panther 95 (DT) |
| Maximum torque declared | 237 lb·ft · 321 N·m | 251 lb·ft · 340 N·m | +6% Panther 95 (DT) |
| Transmission | |||
| Top speed declared | 15.5–24.9 mph · 25–40 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | — | — |
| Pump flow declared | 19.6 gpm · 74.3 L/min | 9.2 gpm · 35.0 L/min | +112% 5220 (DT) |
| Pressure declared | 3,191 psi · 220 bar | — | — |
| Three-point lift, at the coupling points declared | 10,207 lb · 4,630 kg | 9,348 lb · 4,240 kg | +9% 5220 (DT) |
| Rear PTO speeds declared | 635/1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,818 lb · 4,000 kg | 7,242 lb · 3,285 kg | +22% 5220 (DT) |
| Maximum permissible mass declared | 16,535 lb · 7,500 kg | — | — |
| Wheelbase declared | 107.5 in · 2,730 mm | 98.4 in · 2,500 mm | +9% 5220 (DT) |
| Length declared | 163.0 in · 4,140 mm | 161.4 in · 4,100 mm | — |
| Width declared | 79.7 in · 2,025 mm | 82.7–102.4 in · 2,100–2,600 mm | differs |
| Ground clearance declared | 22.1 in · 561 mm | 17.9 in · 455 mm | +23% 5220 (DT) |
| Turning radius, braked declared | — | 12.4 ft · 3.77 m | — |
| Fuel tank declared | 179.6 qt · 170.0 L | 101.4 qt · 96.0 L | +77% 5220 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 5220 (DT) sources
Source
- Source: Traktorenlexikon, “Case-IH 5220”
SAME Panther 95 (DT) sources
Source
- Source: Traktorenlexikon, “SAME Panther 95”