8 material differences · fewer than 12
Tractor oneCase-IH 3220 (DT)1993–1998No measured PTO figureTractor twoCase-IH CS-521998–2001No measured PTO figure
Which should you choose?
Read our verdict on the 3220 (DT) and the CS-52 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 3220 (DT) | CS-52 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 51.2 hp | 51.2 hp | — |
| Engine declared | IHC D-179 | PERKINS 903-27 T | differs |
| Displacement declared | 2.93 L | 2.70 L | +9% 3220 (DT) |
| Maximum torque declared | 134 lb·ft · 182 N·m | 142 lb·ft · 193 N·m | +6% CS-52 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6–24.9 mph · 30–40 km/h | differs |
| Clutch declared | Pedal operated dry single-plate clutch | dry double clutch, pedal-operated driving clutch | differs |
| Hydraulics & hitch | |||
| Pressure declared | — | 3,481 psi · 240 bar | — |
| Three-point lift, at the coupling points declared | 5,401 lb · 2,450 kg | 5,556 lb · 2,520 kg | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,897 lb · 2,675 kg | 5,467 lb · 2,480 kg | +8% 3220 (DT) |
| Wheelbase declared | 79.8 in · 2,027 mm | 83.5 in · 2,121 mm | — |
| Length declared | 139.2 in · 3,535 mm | 140.6 in · 3,570 mm | — |
| Width declared | 72.4–90.6 in · 1,840–2,300 mm | 74.8 in · 1,900 mm | differs |
| Ground clearance declared | 9.3 in · 236 mm | — | — |
| Turning radius, braked declared | 11.5 ft · 3.50 m | — | — |
| Fuel tank declared | 118.3 qt · 112.0 L | 77.1 qt · 73.0 L | +53% 3220 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Case-IH 3220 (DT) sources
- Source: Traktorenlexikon, “Case-IH 3220”
- Source: Traktorenlexikon, “IHC 553”
Case-IH CS-52 sources
- Source: Traktorenlexikon, “Case-IH CS52/a”