BOLINDER-MUNKTELL BM-35/BM-36 or Steyr 40, 40h, 40a?
Which should you choose?
On performance, every comparable figure that differs favours the Steyr 40, 40h, 40a: three-point lift. It is also ahead on forward gears and drive.
- The Steyr 40, 40h, 40a suits loader and hydraulic implement work better on this data: 59% (500 kg / 1,102 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | BM-35/BM-36 | 40, 40h, 40a | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 25.7 kW (35 hp)Traktorenlexikon, “Bolinder-Munktell BM 35/36” | 25.8 kW (34.6 hp)Traktorenlexikon, “Steyr Plus 40” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the BM-35/BM-36 and the 40, 40h, 40a. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the BM-35/BM-36 and the 40, 40h, 40a. |
| Which pumps more oil for implements? | 23.8 L/min (6.3 gpm)Traktorenlexikon, “Bolinder-Munktell BM 35/36” | 23.0 L/min (6.1 gpm)Traktorenlexikon, “Steyr Plus 40” | EvenEven on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which lifts more on the three-point hitch? | 850 kg (1,874 lb)Traktorenlexikon, “Bolinder-Munktell BM 35/36” | 1,350 kg (2,976 lb)Traktorenlexikon, “Steyr Plus 40” | AheadThe Steyr 40, 40h, 40a has 59% more lift (500 kg / 1,102 lb) than the BOLINDER-MUNKTELL BM-35/BM-36 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 2,450 kg (5,401 lb)Traktorenlexikon, “Bolinder-Munktell BM 35/36” | 1,870 kg (4,123 lb)Traktorenlexikon, “Steyr Plus 40” | Ahead (a fact, not an advantage)The BOLINDER-MUNKTELL BM-35/BM-36 is 31% heavier (580 kg / 1,279 lb) than the Steyr 40, 40h, 40a (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | 2,850 kg (6,283 lb)Traktorenlexikon, “Steyr Plus 40” | No figureNo call on maximum permissible mass: no figure on record for the BM-35/BM-36. |
| Which has the wider choice of gears? | 5Traktorenlexikon, “Bolinder-Munktell BM 35/36” | 8Traktorenlexikon, “Steyr Plus 40” | AheadThe Steyr 40, 40h, 40a has 60% more forward gears (3 gears) than the BOLINDER-MUNKTELL BM-35/BM-36 (both forward gears, as stated by the source). |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the BM-35/BM-36 and the 40, 40h, 40a. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “Bolinder-Munktell BM 35/36” | 28 km/h (17.4 mph)Traktorenlexikon, “Steyr Plus 40” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “Bolinder-Munktell BM 35/36” | 540 rpmTraktorenlexikon, “Steyr Plus 40” | EvenEven on PTO speeds: the same speeds (540 rpm). |
| Which PTO runs independently of the ground drive? | — | dependent (stops with the clutch)Traktorenlexikon, “Steyr Plus 40” | No figureNo call on PTO independence: not stated for the BM-35/BM-36. |
| Which drives on both axles? | 2WDTraktorenlexikon, “Bolinder-Munktell BM 35/36” | 2WD / 4WDTraktorenlexikon, “Steyr Plus 40” | AheadThe Steyr 40, 40h, 40a is available with four-wheel drive; the BOLINDER-MUNKTELL BM-35/BM-36 is two-wheel drive (as stated by the sources). |
| Which is newer, and what about parts? | 1952–1959 | 1967–1977 | Ahead (a fact, not an advantage)The Steyr 40, 40h, 40a is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Steyr 40, 40h, 40a has 59% more lift (500 kg / 1,102 lb) than the BOLINDER-MUNKTELL BM-35/BM-36 (both lift at the hitch ends, as stated by the source).
- The BOLINDER-MUNKTELL BM-35/BM-36 is 31% heavier (580 kg / 1,279 lb) than the Steyr 40, 40h, 40a (both unladen weight, as stated by the source).
- The Steyr 40, 40h, 40a has 60% more forward gears (3 gears) than the BOLINDER-MUNKTELL BM-35/BM-36 (both forward gears, as stated by the source).
- The Steyr 40, 40h, 40a is available with four-wheel drive; the BOLINDER-MUNKTELL BM-35/BM-36 is two-wheel drive (as stated by the sources).
- The Steyr 40, 40h, 40a is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on hydraulic flow (both pump flow, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO speeds: the same speeds (540 rpm).
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.
← Every figure for both machines, side by side, with sources