8 material differences · fewer than 12
Tractor oneBOLINDER-MUNKTELL BM-35/BM-361952–1959No measured PTO figureTractor twoMAN Werk München 4P11960–1963No measured PTO figure
Which should you choose?
Read our verdict on the BM-35/BM-36 and the 4P1 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | BM-35/BM-36 | 4P1 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 42.0 hp | 34.3 hp | +22% BM-35/BM-36 |
| Engine declared | BOLINDER-MUNKTELL 1053 | MAN D 8613 M 1/2 | differs |
| Displacement declared | 3.36 L | 1.92 L | +76% BM-35/BM-36 |
| Maximum torque declared | 152 lb·ft · 206 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 12.4–17.6 mph · 19.9–28.3 km/h | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 6.3 gpm · 23.8 L/min | — | — |
| Pressure declared | 1,276 psi · 88 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 1520 | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,401 lb · 2,450 kg | 4,233 lb · 1,920 kg | +28% BM-35/BM-36 |
| Maximum permissible mass declared | — | 6,173 lb · 2,800 kg | — |
| Wheelbase declared | 77.2 in · 1,960 mm | 77.6 in · 1,970 mm | — |
| Length declared | 124.0 in · 3,150 mm | 131.7 in · 3,345 mm | +6% 4P1 |
| Width declared | 66.5 in · 1,690 mm | 65.7 in · 1,670 mm | — |
| Ground clearance declared | 20.7 in · 525 mm | 11.0–15.7 in · 280–400 mm | differs |
| Turning radius, braked declared | 11.2 ft · 3.40 m | 10.8 ft · 3.30 m | — |
| Fuel tank declared | 68.7 qt · 65.0 L | 63.4–2,073.2 qt · 60–1,962 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
BOLINDER-MUNKTELL BM-35/BM-36 sources
- Source: Traktorenlexikon, “Bolinder-Munktell BM 35/36”
MAN Werk München 4P1 sources
- Source: Traktorenlexikon, “MAN 4P1”
- Source: Traktorenlexikon, “MAN 2P1”