11 material differences · fewer than 12
Tractor oneBOLINDER-MUNKTELL 425 Terrier1957–1962No measured PTO figureTractor twoFahr D 130 AH1957–1959No measured PTO figure
Which should you choose?
Read our verdict on the 425 Terrier and the D 130 AH → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | 425 Terrier | D 130 AH | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 31.5 hp | 16.8 hp | +88% 425 Terrier |
| Engine declared | AB-VOLVO B 16 C | Güldner 2 LD | differs |
| Displacement declared | 1.58 L | 1.31 L | +21% 425 Terrier |
| Maximum torque declared | 72 lb·ft · 97 N·m | 48 lb·ft · 65 N·m | +49% 425 Terrier |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 12.0 mph · 19.3 km/h | +55% 425 Terrier |
| Clutch declared | Pedal operated dry single-plate clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 6.3 gpm · 23.8 L/min | — | — |
| Pressure declared | — | 3,129 psi · 216 bar | — |
| Rear PTO speeds declared | 540 rpm | 538 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,175 lb · 1,440 kg | 2,712 lb · 1,230 kg | +17% 425 Terrier |
| Maximum permissible mass declared | — | 4,409 lb · 2,000 kg | — |
| Wheelbase declared | 75.4 in · 1,915 mm | 68.3 in · 1,735 mm | +10% 425 Terrier |
| Length declared | 116.9 in · 2,970 mm | 108.1 in · 2,747 mm | +8% 425 Terrier |
| Width declared | 66.9 in · 1,700 mm | 57.5 in · 1,460 mm | +16% 425 Terrier |
| Ground clearance declared | 17.7 in · 450 mm | 18.3 in · 464 mm | — |
| Turning radius, braked declared | 9.8 ft · 3.00 m | 7.7 ft · 2.35 m | +28% 425 Terrier |
| Fuel tank declared | 42.3 qt · 40.0 L | 31.7 qt · 30 L | +33% 425 Terrier |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
BOLINDER-MUNKTELL 425 Terrier sources
- Source: Traktorenlexikon, “Bolinder-Munktell BM 425 Terrier”
Fahr D 130 AH sources
- Source: Traktorenlexikon, “Fahr D 130 AH”
- Source: Traktorenlexikon, “Fahr D 131 L”