7 material differences · fewer than 12

Tractor oneALLIS-CHALMERS Modell-C1940–1950No measured PTO figureTractor twoInternational Harvester FS1940–1949No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (71%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

7 material differences · 2 fields identical or within 5%, which is not counted as material

ALLIS-CHALMERS Modell-C and International Harvester FS, field by field
FieldModell-CFSGap
Engine
Engine power, claimed claimed18.2 hp19.6 hp+7% FS
Transmission
Top speed declared7.5 mph · 12 km/h3.9 mph · 6.2 km/h+94% Modell-C
Clutch declaredFoot-operated spring-loaded dry Rockford single-plate clutchSingle-disc dry clutchdiffers
Hydraulics & hitch
Rear PTO speeds declared560 rpm550differs
Weight & dimensions
Unladen weight declared2,200 lb · 998 kg3,770 lb · 1,710 kg+71% FS
Wheelbase declared77.0 in · 1,956 mm78.3 in · 1,990 mm—
Length declared110.2 in · 2,800 mm126.0 in · 3,200 mm+14% FS
Width declared68.5 in · 1,740 mm74.8 in · 1,900 mm+9% FS
Ground clearance declared23.0 in · 584 mm15.0 in · 380 mm+54% Modell-C
Fuel tank declared57.7 qt · 54.6 L58.1 qt · 55 L—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

ALLIS-CHALMERS Modell-C sources

Source
  • Source: Traktorenlexikon, “Allis-Chalmers Modell C”

International Harvester FS sources

Source
  • Source: Traktorenlexikon, “IHC FS”