7 material differences · fewer than 12

Tractor oneALLIS-CHALMERS Modell-C1940–1950No measured PTO figureTractor twoInternational Harvester FG (MC Cormick-Deering)1940–1951No measured PTO figure

Which should you choose?

Read our verdict on the Modell-C and the FG → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

7 material differences · 2 fields identical or within 5%, which is not counted as material

ALLIS-CHALMERS Modell-C and International Harvester FG (MC Cormick-Deering), field by field
Field	Modell-C	FG	Gap
Engine
Engine power, claimed claimed	18.2 hp	19.6 hp	+7% FG
Transmission
Top speed declared	7.5 mph · 12 km/h	9.3 mph · 15 km/h	+25% FG
Clutch declared	Foot-operated spring-loaded dry Rockford single-plate clutch	Pedal operated dry single plate clutch	differs
Hydraulics & hitch
Rear PTO speeds declared	560 rpm	550 rpm	differs
Weight & dimensions
Unladen weight declared	2,200 lb · 998 kg	3,924 lb · 1,780 kg	+78% FG
Wheelbase declared	77.0 in · 1,956 mm	78.3 in · 1,990 mm	—
Length declared	110.2 in · 2,800 mm	122.0 in · 3,100 mm	+11% FG
Width declared	68.5 in · 1,740 mm	74.8 in · 1,900 mm	+9% FG
Ground clearance declared	23.0 in · 584 mm	9.1 in · 230 mm	+154% Modell-C
Fuel tank declared	57.7 qt · 54.6 L	58.1 qt · 55.0 L	—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

ALLIS-CHALMERS Modell-C sources

Source

Source: Traktorenlexikon, “Allis-Chalmers Modell C”

International Harvester FG (MC Cormick-Deering) sources