5 material differences · fewer than 12
Tractor oneALLIS-CHALMERS FD-51963–1965No measured PTO figureTractor twoJohn Deere-LANZ 7101965–1967No measured PTO figure
Which should you choose?
Read our verdict on the FD-5 and the 710 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 6 fields identical or within 5%, which is not counted as material
| Field | FD-5 | 710 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 49.3 hp | 49.3 hp | — |
| Engine declared | VENDEUVRE 66 | John Deere 202 D 23 L | differs |
| Displacement declared | — | 3.32 L | — |
| Maximum torque declared | 156 lb·ft · 212 N·m | 132 lb·ft · 178 N·m | +19% FD-5 |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 12.4–15.5 mph · 20–25 km/h | differs |
| Clutch declared | Pedal-operated dry two-stage double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.1 gpm · 15.6 L/min | — |
| Pressure declared | — | 2,162 psi · 149 bar | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 5,412 lb · 2,455 kg | 4,925 lb · 2,234 kg | +10% FD-5 |
| Maximum permissible mass declared | — | 7,716 lb · 3,500 kg | — |
| Wheelbase declared | 89.8 in · 2,281 mm | 86.6 in · 2,200 mm | — |
| Length declared | 129.9 in · 3,300 mm | 139.0 in · 3,530 mm | +7% 710 |
| Width declared | 68.9 in · 1,750 mm | 70.5 in · 1,790 mm | — |
| Ground clearance declared | 19.3 in · 490 mm | 19.7 in · 500 mm | — |
| Turning radius, braked declared | — | 10.2 ft · 3.10 m | — |
| Fuel tank declared | 74.0 qt · 70.0 L | 74.0 qt · 70.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS FD-5 sources
Source
- Source: Traktorenlexikon, “Allis-Chalmers FD 5”
John Deere-LANZ 710 sources
Source
- Source: Traktorenlexikon, “John Deere-Lanz 710”