7 material differences · fewer than 12

Tractor oneALLIS-CHALMERS FD-51963–1965No measured PTO figureTractor twoJohn Deere-LANZ 7001963–1965No measured PTO figure

Which should you choose?

Read our verdict on the FD-5 and the 700 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

7 material differences · 3 fields identical or within 5%, which is not counted as material

ALLIS-CHALMERS FD-5 and John Deere-LANZ 700, field by field
Field	FD-5	700	Gap
Engine
Engine power, claimed claimed	49.3 hp	49.3 hp	—
Engine declared	VENDEUVRE 66	John Deere 405	differs
Displacement declared	—	2.71 L	—
Maximum torque declared	156 lb·ft · 212 N·m	125 lb·ft · 170 N·m	+25% FD-5
Transmission
Top speed declared	15.5 mph · 25 km/h	12.4–18.6 mph · 20–30 km/h	differs
Clutch declared	Pedal-operated dry two-stage double clutch	—	—
Hydraulics & hitch
Rear PTO speeds declared	540/1000 rpm	540/1000 rpm	—
Weight & dimensions
Unladen weight declared	5,412 lb · 2,455 kg	5,071 lb · 2,300 kg	+7% FD-5
Maximum permissible mass declared	—	7,716 lb · 3,500 kg	—
Wheelbase declared	89.8 in · 2,281 mm	76.8 in · 1,950 mm	+17% FD-5
Length declared	129.9 in · 3,300 mm	133.5 in · 3,390 mm	—
Width declared	68.9 in · 1,750 mm	65.0 in · 1,650 mm	+6% FD-5
Ground clearance declared	19.3 in · 490 mm	15.2 in · 385 mm	+27% FD-5
Fuel tank declared	74.0 qt · 70.0 L	—	—

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

ALLIS-CHALMERS FD-5 sources

Source

Source: Traktorenlexikon, “Allis-Chalmers FD 5”

John Deere-LANZ 700 sources