10 material differences · fewer than 12
Tractor oneALLIS-CHALMERS FD-31962–1965No measured PTO figureTractor twoFord 1600 (A)1976–1979No measured PTO figure
Which should you choose?
Read our verdict on the FD-3 and the 1600 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | FD-3 | 1600 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 24.7 hp | 24.7 hp | — |
| Engine declared | VENDEUVRE 52 | ISHIKAWAJIMA-SHIBAURA LE-892 | differs |
| Displacement declared | — | 1.27 L | — |
| Maximum torque declared | 53 lb·ft · 71.6 N·m | — | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 9.3 mph · 15 km/h | +33% FD-3 |
| Clutch declared | Pedal operated dry two stage double clutch | Pedal operated dry double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.2 gpm · 15.9 L/min | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 3,153 lb · 1,430 kg | 2,293 lb · 1,040 kg | +38% FD-3 |
| Maximum permissible mass declared | — | 3,847 lb · 1,745 kg | — |
| Wheelbase declared | 76.8–80.7 in · 1,950–2,050 mm | 62.6 in · 1,590 mm | differs |
| Length declared | 112.2 in · 2,850 mm | 100.0 in · 2,540 mm | +12% FD-3 |
| Width declared | 63.0 in · 1,600 mm | 50.4 in · 1,280 mm | +25% FD-3 |
| Ground clearance declared | 15.7 in · 400 mm | 13.8 in · 350 mm | +14% FD-3 |
| Turning radius, braked declared | — | 8.2 ft · 2.49 m | — |
| Fuel tank declared | 47.6 qt · 45.0 L | 23.2 qt · 22.0 L | +105% FD-3 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS FD-3 sources
- Source: Traktorenlexikon, “Allis-Chalmers FD 3”
Ford 1600 (A) sources
- Source: Traktorenlexikon, “Ford 1600”
- Source: Traktorenlexikon, “Ford 1000”