10 material differences · fewer than 12
Tractor oneALLIS-CHALMERS D-171957–1967No measured PTO figureTractor twoMassey Ferguson MF 1521972–1976No measured PTO figure
Which should you choose?
We will not advise between these two machines, because they were not built in overlapping years (1957–1967; 1972–1976). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | D-17 | MF 152 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 46.1 hp | 46.4 hp | — |
| Engine declared | ALLIS-CHALMERS G-226 | Perkins AD 3.152 | differs |
| Displacement declared | — | 2.50 L | — |
| Maximum torque declared | — | 129 lb·ft · 175 N·m | — |
| Transmission | |||
| Top speed declared | 12.4 mph · 20 km/h | 15.5 mph · 25 km/h | +25% MF 152 |
| Clutch declared | Foot-operated spring-loaded dry single-plate Rockford clutch | Pedal operated dry and air-cooled MF double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 10.5 gpm · 39.7 L/min | 4.9 gpm · 18.4 L/min | +116% D-17 |
| Pressure declared | — | 2,347 psi · 162 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,868 lb · 2,208 kg | 3,933 lb · 1,784 kg | +24% D-17 |
| Wheelbase declared | 93.0–95.7 in · 2,362–2,432 mm | 81.1 in · 2,060 mm | differs |
| Length declared | 140.0–143.0 in · 3,556–3,632 mm | 126.0 in · 3,200 mm | differs |
| Width declared | 76.7 in · 1,949 mm | 72.8 in · 1,850 mm | +5% D-17 |
| Ground clearance declared | 22.8 in · 580 mm | 13.8 in · 350 mm | +66% D-17 |
| Fuel tank declared | 75.9 qt · 71.8 L | 50.4 qt · 47.7 L | +51% D-17 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS D-17 sources
- Source: Traktorenlexikon, “Allis-Chalmers D 17”
Massey Ferguson MF 152 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 152”
- Source: Traktorenlexikon, “Massey Ferguson MF 148”
- Source: Traktorenlexikon, “Massey Ferguson MF 152 S”