8 material differences · fewer than 12
Tractor oneALLIS-CHALMERS 220 Landhandler1969–1973No measured PTO figureTractor twoVALMET 15021975–1980No measured PTO figure
Which should you choose?
Read our verdict on the 220 Landhandler and the 1502 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 220 Landhandler | 1502 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 136.1 hp | 134 hp | — |
| Engine declared | ALLIS-CHALMERS D-3500 | VALMET 611 CS | differs |
| Displacement declared | 6.97 L | 6.60 L | +6% 220 Landhandler |
| Maximum torque declared | — | 406 lb·ft · 550 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | — | Dry Fichtel & Sachs double clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 16.5 gpm · 62.5 L/min | — | — |
| Rear PTO speeds declared | 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 12,161 lb · 5,516 kg | 16,469 lb · 7,470 kg | +35% 1502 |
| Wheelbase declared | 100.0 in · 2,539 mm | 101.3 in · 2,572 mm | — |
| Length declared | 164.0 in · 4,166 mm | 209.8 in · 5,330 mm | +28% 1502 |
| Width declared | 96.0 in · 2,438 mm | 83.7 in · 2,125 mm | +15% 220 Landhandler |
| Ground clearance declared | 21.0 in · 533 mm | 16.5 in · 420 mm | +27% 220 Landhandler |
| Turning radius, braked declared | 11.3 ft · 3.45 m | — | — |
| Fuel tank declared | 203.9 qt · 193.0 L | 190.2 qt · 180.0 L | +7% 220 Landhandler |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 220 Landhandler sources
- Source: Traktorenlexikon, “Allis-Chalmers 220”
- Source: Traktorenlexikon, “Allis-Chalmers 210”
VALMET 1502 sources
- Source: Traktorenlexikon, “Valmet 1502”