8 material differences · fewer than 12
Tractor oneALLIS-CHALMERS 2001972–1975No measured PTO figureTractor twoSchlüter Compact 950T (TV)1971–1974No measured PTO figure
Which should you choose?
We will not advise between these two machines, because the drive differs (2WD; Two-wheel or four-wheel drive). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 200 | Compact 950T (TV) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 93.7 hp | 94 hp | — |
| Engine declared | ALLIS-CHALMERS D-2900 | Schlüter SDMT 110 W4 | differs |
| Displacement declared | 4.93 L | 4.75 L | — |
| Maximum torque declared | — | 301 lb·ft · 408 N·m | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 16.8 mph · 27.0 km/h | +8% Compact 950T (TV) |
| Clutch declared | — | Single-disc dry clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 17.2 gpm · 65.1 L/min | — | — |
| Rear PTO speeds declared | 540 rpm / 1000 rpm | 582/972 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 8,845 lb · 4,012 kg | 7,959 lb · 3,610 kg | +11% 200 |
| Wheelbase declared | 105.7 in · 2,686 mm | 92.4 in · 2,346 mm | +14% 200 |
| Length declared | 157.5 in · 4,000 mm | 155.5 in · 3,950 mm | — |
| Width declared | 87.6 in · 2,226 mm | 80.7 in · 2,050 mm | +9% 200 |
| Ground clearance declared | 21.4 in · 543 mm | 15.9 in · 405 mm | +34% 200 |
| Turning radius, braked declared | 11.1 ft · 3.38 m | 11.8 ft · 3.60 m | +7% Compact 950T (TV) |
| Fuel tank declared | 192.0 qt · 181.7 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
ALLIS-CHALMERS 200 sources
- Source: Traktorenlexikon, “Allis-Chalmers 200”
- Source: Traktorenlexikon, “Allis-Chalmers 190XT”
Schlüter Compact 950T (TV) sources
- Source: Traktorenlexikon, “Schlüter Compact 950T /950TV”
- Source: Traktorenlexikon, “Schlüter Compact 1050T /1050TV”