7 material differences · fewer than 12
Tractor oneAllgaier R181946–1952No measured PTO figureTractor twoKramer KL 2001958–1967No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (26%); they were not built in overlapping years (1946–1952; 1958–1967). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | R18 | KL 200 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 17.7 hp | 17.7 hp | — |
| Maximum torque declared | — | 64 lb·ft · 86 N·m | — |
| Transmission | |||
| Top speed declared | 11.8 mph · 19 km/h | 12.4 mph · 20 km/h | +5% KL 200 |
| Clutch declared | Single dry clutch | Single-plate dry clutch from Fichtel & Sachs | differs |
| Hydraulics & hitch | |||
| Pump flow declared | — | 4.2 gpm · 16 L/min | — |
| Pressure declared | — | 1,707 psi · 118 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,527 lb · 1,600 kg | 2,800–3,153 lb · 1,270–1,430 kg | differs |
| Maximum permissible mass declared | — | 4,012 lb · 1,820 kg | — |
| Wheelbase declared | 59.1 in · 1,500 mm | 69.5–71.9 in · 1,765–1,825 mm | differs |
| Length declared | 102.4 in · 2,600 mm | 111.0–113.4 in · 2,820–2,880 mm | differs |
| Width declared | 58.3 in · 1,480 mm | 58.7–59.1 in · 1,490–1,500 mm | — |
| Ground clearance declared | 13.8 in · 350 mm | 13.8–15.7 in · 350–400 mm | differs |
| Turning radius, braked declared | 8.2 ft · 2.50 m | — | — |
| Fuel tank declared | 29.6 qt · 28 L | 25.4 qt · 24 L | +17% R18 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Allgaier R18 sources
- Source: Traktorenlexikon, “Allgaier R18”
Kramer KL 200 sources
- Source: Traktorenlexikon, “Kramer KL 200”