10 material differences · fewer than 12
Tractor oneAGRIFULL Tornado 80 (DT)1977–1980No measured PTO figureTractor twoSAME Saturno 80 (DT)1972–1980No measured PTO figure
Which should you choose?
Read our verdict on the Tornado 80 (DT) and the Saturno 80 (DT) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | Tornado 80 (DT) | Saturno 80 (DT) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 75.9 hp | 75.9 hp | — |
| Engine declared | V.M.-MOTORI 1054 SU | SAME DA 039-1054 L or 1054 P | differs |
| Displacement declared | 3.81 L | 4.15 L | +9% Saturno 80 (DT) |
| Maximum torque declared | 137 lb·ft · 186 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 15.5–18.6 mph · 25–30 km/h | differs |
| Clutch declared | — | Pedal-operated dry two-stage SAME double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 7.9 gpm · 30.0 L/min | — | — |
| Pressure declared | 3,118 psi · 215 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,046 lb · 3,196 kg | 6,085 lb · 2,760 kg | +16% Tornado 80 (DT) |
| Wheelbase declared | 98.4 in · 2,500 mm | 92.5 in · 2,350 mm | +6% Tornado 80 (DT) |
| Length declared | 164.6 in · 4,180 mm | 143.7 in · 3,650 mm | +15% Tornado 80 (DT) |
| Width declared | 80.7 in · 2,050 mm | 76.0–95.7 in · 1,930–2,430 mm | differs |
| Ground clearance declared | 16.1 in · 410 mm | 19.7 in · 500 mm | +22% Saturno 80 (DT) |
| Turning radius, braked declared | 11.8 ft · 3.60 m | 11.5 ft · 3.50 m | — |
| Fuel tank declared | 153.2 qt · 145.0 L | 84.5 qt · 80.0 L | +81% Tornado 80 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGRIFULL Tornado 80 (DT) sources
- Source: Traktorenlexikon, “Agrifull Tornedo 80”
SAME Saturno 80 (DT) sources
- Source: Traktorenlexikon, “SAME Saturno 80 Synchro”