8 material differences · fewer than 12
Tractor oneAGRIFULL Tornado 80 (DT)1977–1980No measured PTO figureTractor twoJohn Deere 2555 (A)1984–1992No measured PTO figure
Which should you choose?
Read our verdict on the Tornado 80 (DT) and the 2555 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | Tornado 80 (DT) | 2555 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 75.9 hp | 76.0 hp | — |
| Engine declared | V.M.-MOTORI 1054 SU | John Deere 4.239 DL-008 or TL-006 | differs |
| Displacement declared | 3.81 L | 3.92 L | — |
| Maximum torque declared | 137 lb·ft · 186 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 2555 (A) |
| Clutch declared | — | Pedal-operated dry LuK single-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | — | Closed centre | — |
| Pump flow declared | 7.9 gpm · 30.0 L/min | — | — |
| Pressure declared | 3,118 psi · 215 bar | 3,336 psi · 230 bar | +7% 2555 (A) |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,046 lb · 3,196 kg | 7,110 lb · 3,225 kg | — |
| Wheelbase declared | 98.4 in · 2,500 mm | 89.7 in · 2,279 mm | +10% Tornado 80 (DT) |
| Length declared | 164.6 in · 4,180 mm | 145.0 in · 3,683 mm | +13% Tornado 80 (DT) |
| Width declared | 80.7 in · 2,050 mm | 89.4 in · 2,270 mm | +11% 2555 (A) |
| Ground clearance declared | 16.1 in · 410 mm | 16.1 in · 410 mm | — |
| Turning radius, braked declared | 11.8 ft · 3.60 m | — | — |
| Fuel tank declared | 153.2 qt · 145.0 L | 88.8 qt · 84.0 L | +73% Tornado 80 (DT) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGRIFULL Tornado 80 (DT) sources
- Source: Traktorenlexikon, “Agrifull Tornedo 80”
John Deere 2555 (A) sources
- Source: Traktorenlexikon, “John Deere 2555”