7 material differences · fewer than 12
Tractor oneAGRIFULL 80-95 Turbo (DT)1980–1986No measured PTO figureTractor twoFord 7610 (A)1981–1991No measured PTO figure
Which should you choose?
Read our verdict on the 80-95 Turbo (DT) and the 7610 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 80-95 Turbo (DT) | 7610 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 93.7 hp | 93.7 hp | — |
| Engine declared | V.M.-MOTTORI VM 1054 Turbo | — | — |
| Displacement declared | 3.81 L | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 18.6 mph · 30 km/h | +20% 7610 (A) |
| Clutch declared | Dry VALEO or LuK double clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 7.9 gpm · 30.0 L/min | 9.9 gpm · 37.5 L/min | +25% 7610 (A) |
| Pressure declared | 3,118 psi · 215 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 7,253 lb · 3,290 kg | 6,314 lb · 2,864 kg | +15% 80-95 Turbo (DT) |
| Wheelbase declared | 98.4 in · 2,500 mm | 87.5 in · 2,223 mm | +12% 80-95 Turbo (DT) |
| Length declared | 150.2 in · 3,815 mm | 146.5 in · 3,720 mm | — |
| Width declared | 80.7–97.2 in · 2,050–2,470 mm | 77.0 in · 1,955 mm | differs |
| Ground clearance declared | 16.9 in · 430 mm | 19.3 in · 490 mm | +14% 7610 (A) |
| Turning radius, braked declared | — | 11.2 ft · 3.40 m | — |
| Fuel tank declared | 84.5 qt · 80.0 L | 138.4–156.4 qt · 131.0–148.0 L | differs |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGRIFULL 80-95 Turbo (DT) sources
- Source: Traktorenlexikon, “Agrifull 80-95”
Ford 7610 (A) sources
- Source: Traktorenlexikon, “Ford 7610”