AGRIFULL 80-50 (DT) or Case-Steyr M 948 (a)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 80-50 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the M 948 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Case-Steyr M 948 (a) suits loader and hydraulic implement work better on this data: 40% (8.8 L/min / 2.3 gpm) more hydraulic flow and 64% (869 kg / 1,916 lb) more three-point lift.
  • The Case-Steyr M 948 (a) suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for AGRIFULL 80-50 (DT) and Case-Steyr M 948 (a), with the call on each
Question80-50 (DT)M 948 (a)Call
Which puts more power through the PTO shaft?35.3 kW (47.3 hp)Traktorenlexikon, “Agrifull 80-50”35.3 kW (47.3 hp)Traktorenlexikon, “Steyr M 948”Not comparableNot comparable on power at the PTO shaft: the 80-50 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the M 948 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 80-50 (DT) and the M 948 (a).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 80-50 (DT) and the M 948 (a).
Which pumps more oil for implements?22.0 L/min (5.8 gpm)Traktorenlexikon, “Agrifull 80-50”30.8 L/min (8.1 gpm)Traktorenlexikon, “Steyr M 948”AheadThe Case-Steyr M 948 (a) has 40% more hydraulic flow (8.8 L/min / 2.3 gpm) than the AGRIFULL 80-50 (DT) (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?1,351 kg (2,978 lb)Traktorenlexikon, “Agrifull 80-50”2,220 kg (4,894 lb)Traktorenlexikon, “Steyr M 948”AheadThe Case-Steyr M 948 (a) has 64% more lift (869 kg / 1,916 lb) than the AGRIFULL 80-50 (DT) (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?1,790 kg (3,946 lb)Traktorenlexikon, “Agrifull 80-50”2,360 kg (5,203 lb)Traktorenlexikon, “Steyr M 948”Ahead (a fact, not an advantage)The Case-Steyr M 948 (a) is 32% heavier (570 kg / 1,257 lb) than the AGRIFULL 80-50 (DT) (both unladen weight, as stated by the source).
Which may carry more ballast and load?4,200 kg (9,259 lb)Traktorenlexikon, “Steyr M 948”No figureNo call on maximum permissible mass: no figure on record for the 80-50 (DT).
Which has the wider choice of gears?9Traktorenlexikon, “Agrifull 80-50”16 to 32Traktorenlexikon, “Steyr M 948”AheadThe Case-Steyr M 948 (a) has 78% more forward gears (7 gears) than the AGRIFULL 80-50 (DT) (both forward gears, as stated by the source).
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 80-50 (DT) and the M 948 (a).
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Agrifull 80-50”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Steyr M 948”AheadThe Case-Steyr M 948 (a) has 20% more top speed (5.0 km/h / 3.1 mph) than the AGRIFULL 80-50 (DT) (both top speed forward, as stated by the source).
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Agrifull 80-50”540/1000 rpmTraktorenlexikon, “Steyr M 948”AheadThe Case-Steyr M 948 (a) offers 1000 rpm at the PTO, which the AGRIFULL 80-50 (DT) does not (as stated by the sources).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Agrifull 80-50”No figureNo call on PTO independence: not stated for the M 948 (a).
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Agrifull 80-50”2WD / 4WDTraktorenlexikon, “Steyr M 948”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1981–19861996–2001Ahead (a fact, not an advantage)The Case-Steyr M 948 (a) is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Case-Steyr M 948 (a) has 40% more hydraulic flow (8.8 L/min / 2.3 gpm) than the AGRIFULL 80-50 (DT) (both pump flow, as stated by the source).
  • The Case-Steyr M 948 (a) has 64% more lift (869 kg / 1,916 lb) than the AGRIFULL 80-50 (DT) (both lift at the hitch ends, as stated by the source).
  • The Case-Steyr M 948 (a) is 32% heavier (570 kg / 1,257 lb) than the AGRIFULL 80-50 (DT) (both unladen weight, as stated by the source).
  • The Case-Steyr M 948 (a) has 78% more forward gears (7 gears) than the AGRIFULL 80-50 (DT) (both forward gears, as stated by the source).
  • The Case-Steyr M 948 (a) has 20% more top speed (5.0 km/h / 3.1 mph) than the AGRIFULL 80-50 (DT) (both top speed forward, as stated by the source).
  • The Case-Steyr M 948 (a) offers 1000 rpm at the PTO, which the AGRIFULL 80-50 (DT) does not (as stated by the sources).
  • The Case-Steyr M 948 (a) is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the 80-50 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the M 948 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources