10 material differences · fewer than 12

Tractor oneAGRIFULL 355-C1976–1977No measured PTO figureTractor twoEicher 3056 S1982–1990No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (27%); the drive differs (Tracks; 2WD); they were not built in overlapping years (1976–1977; 1982–1990); the 355-C is on tracks, not an alternative to an ordinary tractor. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

10 material differences · 2 fields identical or within 5%, which is not counted as material

AGRIFULL 355-C and Eicher 3056 S, field by field
Field355-C3056 SGap
Engine
Engine power, claimed claimed55.3 hp55 hp—
Engine declaredV.M.-MOTORI 1053Eicher EDL 3-8differs
Displacement declared2.86 L2.93 L—
Maximum torque declared127 lb·ft · 172 N·m——
Transmission
Top speed declared6.2 mph · 10 km/h15.5–24.9 mph · 25–40 km/hdiffers
Clutch declaredHand lever operated dry single disc clutch with dead center engagement——
Hydraulics & hitch
Pump flow declared5.3 gpm · 20.0 L/min6.6 gpm · 25 L/min+25% 3056 S
Pressure declared—3,046 psi · 210 bar—
Rear PTO speeds declared540 rpm540 rpm / 750 rpm / 1000 rpmdiffers
Weight & dimensions
Unladen weight declared5,335 lb · 2,420 kg6,801 lb · 3,085 kg+27% 3056 S
Maximum permissible mass declared—8,818 lb · 4,000 kg—
Wheelbase declared47.2 in · 1,200 mm95.5 in · 2,425 mm+102% 3056 S
Length declared86.6 in · 2,200 mm139.0 in · 3,530 mm+60% 3056 S
Width declared45.2 in · 1,147 mm78.5 in · 1,995 mm+74% 3056 S
Ground clearance declared11.0 in · 280 mm19.9 in · 505 mm+80% 3056 S
Turning radius, braked declared—12.5 ft · 3.80 m—
Fuel tank declared47.6 qt · 45.0 L103.6 qt · 98 L+118% 3056 S

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

AGRIFULL 355-C sources

Source
  • Source: Traktorenlexikon, “Agrifull 355 C”

Eicher 3056 S sources

Source
  • Source: Traktorenlexikon, “Eicher 3056”
  • Source: Traktorenlexikon, “Eicher 656 PA”