10 material differences · fewer than 12
Tractor oneAGRIFULL 355-C1976–1977No measured PTO figureTractor twoEicher 3056 AS1982–1990No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (35%); the drive differs (Tracks; 4WD); they were not built in overlapping years (1976–1977; 1982–1990); the 355-C is on tracks, not an alternative to an ordinary tractor. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 355-C | 3056 AS | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 55.3 hp | 55 hp | — |
| Engine declared | V.M.-MOTORI 1053 | Eicher EDL 3-8 | differs |
| Displacement declared | 2.86 L | 2.93 L | — |
| Maximum torque declared | 127 lb·ft · 172 N·m | — | — |
| Transmission | |||
| Top speed declared | 6.2 mph · 10 km/h | 15.5–24.9 mph · 25–40 km/h | differs |
| Clutch declared | Hand lever operated dry single disc clutch with dead center engagement | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 5.3 gpm · 20.0 L/min | 11.6 gpm · 44.0 L/min | +120% 3056 AS |
| Rear PTO speeds declared | 540 rpm | 540 rpm / 750 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 5,335 lb · 2,420 kg | 7,176 lb · 3,255 kg | +35% 3056 AS |
| Maximum permissible mass declared | — | 8,818 lb · 4,000 kg | — |
| Wheelbase declared | 47.2 in · 1,200 mm | 92.5 in · 2,350 mm | +96% 3056 AS |
| Length declared | 86.6 in · 2,200 mm | 141.3 in · 3,590 mm | +63% 3056 AS |
| Width declared | 45.2 in · 1,147 mm | 78.5 in · 1,995 mm | +74% 3056 AS |
| Ground clearance declared | 11.0 in · 280 mm | 14.0 in · 355 mm | +27% 3056 AS |
| Turning radius, braked declared | — | 14.4 ft · 4.40 m | — |
| Fuel tank declared | 47.6 qt · 45.0 L | 103.6 qt · 98 L | +118% 3056 AS |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGRIFULL 355-C sources
- Source: Traktorenlexikon, “Agrifull 355 C”
Eicher 3056 AS sources
- Source: Traktorenlexikon, “Eicher 3056 A”
- Source: Traktorenlexikon, “Eicher 656 PA”