Agco LT-85 A (Traktorenlexikon) or UTB U-1033 (DT)?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the LT-85 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the U-1033 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Agco LT-85A suits road haulage better on this data: 60% (15.0 km/h / 9.3 mph) more top speed.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Agco LT-85 A (Traktorenlexikon) and UTB U-1033 (DT), with the call on each
QuestionLT-85 AU-1033 (DT)Call
Which puts more power through the PTO shaft?77.2 kW (103.5 hp)Traktorenlexikon, “AGCO LT 85 A”77.2 kW (103.5 hp)Traktorenlexikon, “UTB U 1033 DT”Not comparableNot comparable on power at the PTO shaft: the LT-85 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the U-1033 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the LT-85 A and the U-1033 (DT).
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the LT-85 A and the U-1033 (DT).
Which pumps more oil for implements?61.3 L/min (16.2 gpm)Traktorenlexikon, “AGCO LT 85 A”—No figureNo call on hydraulic flow: no figure on record for the U-1033 (DT).
Which lifts more on the three-point hitch?—3,570.000 kg (7,871 lb)Traktorenlexikon, “UTB U 1033 DT”No figureNo call on three-point lift: no figure on record for the LT-85 A.
Which is heavier, for traction?4,810 kg (10,604 lb)Traktorenlexikon, “AGCO LT 85 A”4,400 kg (9,700 lb)Traktorenlexikon, “UTB U 1033 DT”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the LT-85 A and the U-1033 (DT).
Which has the wider choice of gears?16Traktorenlexikon, “AGCO LT 85 A”16Traktorenlexikon, “UTB U 1033 DT”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?—YesTraktorenlexikon, “UTB U 1033 DT”No figureNo call on a creeper range: not stated for the LT-85 A.
Which is faster on the road?40 km/h (24.9 mph)Traktorenlexikon, “AGCO LT 85 A”25 km/h (15.5 mph)Traktorenlexikon, “UTB U 1033 DT”AheadThe Agco LT-85A has 60% more top speed (15.0 km/h / 9.3 mph) than the UTB U-1033 (DT) (both top speed forward, as stated by the source).
Which offers more PTO speeds?540 rpm / 1000 rpmTraktorenlexikon, “AGCO LT 85 A”540/1000 rpmTraktorenlexikon, “UTB U 1033 DT”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “AGCO LT 85 A”—No figureNo call on PTO independence: not stated for the U-1033 (DT).
Which drives on both axles?4WDTraktorenlexikon, “AGCO LT 85 A”; OECD test report 2514, 2009Two-wheel or four-wheel driveTraktorenlexikon, “UTB U 1033 DT”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?2008–20101994–2004Ahead (a fact, not an advantage)The Agco LT-85A is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Agco LT-85A has 60% more top speed (15.0 km/h / 9.3 mph) than the UTB U-1033 (DT) (both top speed forward, as stated by the source).
  • The Agco LT-85A is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • Not comparable on power at the PTO shaft: the LT-85 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the U-1033 (DT) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, three-point lift, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources