11 material differences · fewer than 12
Tractor oneAgco LT-702002–2004No measured PTO figureTractor twoLandini R-7860 (DT) TL-20 N/M (TL-20 DT/M)1988–2000No measured PTO figure
Which should you choose?
Read our verdict on the LT-70 and the R-7860 (DT) TL-20 N/M (TL-20 DT/M) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | LT-70 | R-7860 (DT) TL-20 N/M (TL-20 DT/M) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 70.0 hp | 70.0 hp | — |
| Engine declared | CUMMINS B 3.9 T | Perkins LD 4.236 | differs |
| Displacement declared | 3.93 L | 3.87 L | — |
| Maximum torque declared | 235 lb·ft · 319 N·m | 195 lb·ft · 264 N·m | +21% LT-70 |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Pedal-operated dry single-disc clutch | Dry and air-cooled OMG double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 10.6 gpm · 40.1 L/min | 9.8 gpm · 37.2 L/min | +8% LT-70 |
| Pressure declared | 3,046 psi · 210 bar | 2,756 psi · 190 bar | +11% LT-70 |
| Three-point lift, at the coupling points declared | 3,347 lb · 1,518 kg | 4,698 lb · 2,131 kg | +40% R-7860 (DT) TL-20 N/M (TL-20 DT/M) |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 8,150 lb · 3,697 kg | 6,305 lb · 2,860 kg | +29% LT-70 |
| Wheelbase declared | 96.0 in · 2,438 mm | 89.8 in · 2,281 mm | +7% LT-70 |
| Length declared | 165.0 in · 4,191 mm | 146.1 in · 3,710 mm | +13% LT-70 |
| Width declared | 83.0 in · 2,108 mm | 78.3 in · 1,990 mm | +6% LT-70 |
| Ground clearance declared | — | 20.3 in · 515 mm | — |
| Turning radius, braked declared | — | 13.0 ft · 3.96 m | — |
| Fuel tank declared | 136.0 qt · 128.7 L | 90.9 qt · 86.0 L | +50% LT-70 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco LT-70 sources
- Source: Traktorenlexikon, “AGCO LT 70”
- Source: Traktorenlexikon, “White 6410”
Landini R-7860 (DT) TL-20 N/M (TL-20 DT/M) sources
- Source: Traktorenlexikon, “Landini 7860”
- Source: Traktorenlexikon, “Massey Ferguson MF 373”