10 material differences · fewer than 12
Tractor oneAgco DT-2252002–2004No measured PTO figureTractor twoFendt 722 Variofrom 2011No measured PTO figure
Which should you choose?
Read our verdict on the DT-225 and the 722 Vario → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | DT-225 | 722 Vario | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 224.9 hp | 219 hp | — |
| Engine declared | CUMMINS CTA-8.3 | Deutz TCD 6.1 L6 4V | differs |
| Displacement declared | 8.27 L | 6.06 L | +37% DT-225 |
| Maximum torque declared | 677 lb·ft · 918 N·m | 729 lb·ft · 988 N·m | +8% 722 Vario |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 31.1 mph · 50 km/h | +25% 722 Vario |
| Clutch declared | Pedal-operated wet multi-disc clutch | multi-plate clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 29.9 gpm · 113.2 L/min | 28.8 gpm · 109.0 L/min | — |
| Pressure declared | 3,046 psi · 210 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 19,745 lb · 8,956 kg | 17,417 lb · 7,900 kg | +13% DT-225 |
| Wheelbase declared | 121.0 in · 3,073 mm | 109.6 in · 2,783 mm | +10% DT-225 |
| Length declared | 203.0 in · 5,156 mm | 206.3 in · 5,240 mm | — |
| Width declared | 98.2 in · 2,494 mm | 100.4 in · 2,550 mm | — |
| Ground clearance declared | 16.9 in · 430 mm | 21.7 in · 552 mm | +28% 722 Vario |
| Fuel tank declared | 479.7 qt · 454.0 L | 422.7 qt · 400 L | +14% DT-225 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-225 sources
- Source: Traktorenlexikon, “AGCO DT 225”
- Source: Traktorenlexikon, “AGCO DT 180”
Fendt 722 Vario sources
- Source: Traktorenlexikon, “Fendt 722 Vario”
- Source: Traktorenlexikon, “Fendt 720 Vario”