10 material differences · fewer than 12
Tractor oneAgco DT-220 A2005–2008No measured PTO figureTractor twoFendt Favorit 926 Vario1996–2002No measured PTO figure
Which should you choose?
Read our verdict on the DT-220 A and the Favorit 926 Vario → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | DT-220 A | Favorit 926 Vario | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 256.4 hp | 256 hp | — |
| Engine declared | SISU-DIESEL 84 ETA | MAN D 0826 LE 531 | differs |
| Displacement declared | 8.42 L | 6.87 L | +23% DT-220 A |
| Maximum torque declared | 763 lb·ft · 1,035 N·m | 807 lb·ft · 1,094 N·m | +6% Favorit 926 Vario |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 31.1 mph · 50 km/h | differs |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | Load sensing | — |
| Pump flow declared | 36.9 gpm · 139.8 L/min | 26.9 gpm · 102.0 L/min | +37% DT-220 A |
| Pressure declared | — | 2,915 psi · 201 bar | — |
| Rear PTO speeds declared | 540/1000/540E rpm | 750 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 20,371 lb · 9,240 kg | 18,188 lb · 8,250 kg | +12% DT-220 A |
| Maximum permissible mass declared | 30,865 lb · 14,000 kg | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 121.1 in · 3,075 mm | 111.8 in · 2,840 mm | +8% DT-220 A |
| Length declared | 209.4 in · 5,320 mm | 194.5 in · 4,940 mm | +8% DT-220 A |
| Width declared | 100.4 in · 2,550 mm | 102.0 in · 2,590 mm | — |
| Ground clearance declared | 19.7 in · 500 mm | 23.8 in · 605 mm | +21% Favorit 926 Vario |
| Turning radius, braked declared | — | 16.7 ft · 5.10 m | — |
| Fuel tank declared | 697.4 qt · 660.0 L | — | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-220 A sources
- Source: Traktorenlexikon, “AGCO DT 220 A”
Fendt Favorit 926 Vario sources
- Source: Traktorenlexikon, “Fendt Favorit 926 Vario”