10 material differences · fewer than 12
Tractor oneAgco DT-205 B2009–2010No measured PTO figureTractor twoFendt 724 Variofrom 2011No measured PTO figure
Which should you choose?
Read our verdict on the DT-205 B and the 724 Vario → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | DT-205 B | 724 Vario | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 236.7 hp | 233 hp | — |
| Engine declared | SISU-DIESEL 84 CTA-4V | Deutz TCD 6.1 L6 | differs |
| Displacement declared | 8.42 L | 6.06 L | +39% DT-205 B |
| Maximum torque declared | — | 780 lb·ft · 1,058 N·m | — |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 31.1 mph · 50 km/h | differs |
| Clutch declared | — | PTO multi-disc clutch | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 25.3 gpm · 95.6 L/min | — | — |
| Pressure declared | 3,336 psi · 230 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 25,838 lb · 11,720 kg | 17,417 lb · 7,900 kg | +48% DT-205 B |
| Maximum permissible mass declared | — | 27,558 lb · 12,500 kg | — |
| Wheelbase declared | 122.2 in · 3,105 mm | 109.6 in · 2,783 mm | +12% DT-205 B |
| Length declared | 223.2 in · 5,670 mm | 206.3 in · 5,240 mm | +8% DT-205 B |
| Width declared | 79.3 in · 2,014 mm | 100.4 in · 2,550 mm | +27% 724 Vario |
| Ground clearance declared | 18.5 in · 470 mm | 21.7 in · 552 mm | +17% 724 Vario |
| Turning radius, braked declared | 24.3 ft · 7.40 m | — | — |
| Fuel tank declared | 623.4 qt · 590.0 L | 422.7 qt · 400 L | +48% DT-205 B |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-205 B sources
- Source: Traktorenlexikon, “AGCO DT 205 B”
Fendt 724 Vario sources
- Source: Traktorenlexikon, “Fendt 724 Vario”
- Source: Traktorenlexikon, “Fendt 819 Vario”