8 material differences · fewer than 12
Tractor oneAgco DT-2002002–2004No measured PTO figureTractor twoSchlüter Super 2000 LS1993No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (29%); they were not built in overlapping years (2002–2004; 1993–1993). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
8 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | DT-200 | Super 2000 LS | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 200.2 hp | 200 hp | — |
| Engine declared | CUMMINS CTA-8.3 | MAN D 0826 LE 501 | differs |
| Displacement declared | 8.27 L | 6.87 L | +20% DT-200 |
| Maximum torque declared | 715 lb·ft · 970 N·m | — | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 23.2–31.1 mph · 37.3–50.0 km/h | differs |
| Clutch declared | Pedal operated wet multi disc clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 29.1 gpm · 110.2 L/min | — | — |
| Pressure declared | 2,350 psi · 162 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 674/978 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 19,630 lb · 8,904 kg | 15,212 lb · 6,900 kg | +29% DT-200 |
| Wheelbase declared | 121.0 in · 3,073 mm | 110.6 in · 2,810 mm | +9% DT-200 |
| Length declared | 203.0 in · 5,156 mm | 187.4 in · 4,760 mm | +8% DT-200 |
| Width declared | 98.2 in · 2,494 mm | 98.4 in · 2,500 mm | — |
| Ground clearance declared | 17.5 in · 445 mm | — | — |
| Turning radius, braked declared | — | 15.4 ft · 4.70 m | — |
| Fuel tank declared | 479.7 qt · 454.0 L | 327.6 qt · 310 L | +46% DT-200 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-200 sources
- Source: Traktorenlexikon, “AGCO DT 200”
- Source: Traktorenlexikon, “AGCO DT 180”
Schlüter Super 2000 LS sources
- Source: Traktorenlexikon, “Schlüter Super 2000 LS”