11 material differences · fewer than 12
Tractor oneAgco DT-2002002–2004No measured PTO figureTractor twoFendt 820 Vario2006–2011No measured PTO figure
Which should you choose?
Read our verdict on the DT-200 and the 820 Vario → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
11 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | DT-200 | 820 Vario | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 200.2 hp | 202 hp | — |
| Engine declared | CUMMINS CTA-8.3 | Deutz AG TCD 2012 LO6 4V | differs |
| Displacement declared | 8.27 L | 6.06 L | +37% DT-200 |
| Maximum torque declared | 715 lb·ft · 970 N·m | 660 lb·ft · 895 N·m | +8% DT-200 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 31.1 mph · 50 km/h | +25% 820 Vario |
| Clutch declared | Pedal operated wet multi disc clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | 29.1 gpm · 110.2 L/min | — | — |
| Pressure declared | 2,350 psi · 162 bar | 2,901 psi · 200 bar | +23% 820 Vario |
| Rear PTO speeds declared | 1000 rpm | 540/540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 19,630 lb · 8,904 kg | 15,840 lb · 7,185 kg | +24% DT-200 |
| Wheelbase declared | 121.0 in · 3,073 mm | 107.1 in · 2,720 mm | +13% DT-200 |
| Length declared | 203.0 in · 5,156 mm | 187.1 in · 4,753 mm | +8% DT-200 |
| Width declared | 98.2 in · 2,494 mm | 101.2 in · 2,570 mm | — |
| Ground clearance declared | 17.5 in · 445 mm | 22.3 in · 566 mm | +27% 820 Vario |
| Turning radius, braked declared | — | 18.4 ft · 5.60 m | — |
| Fuel tank declared | 479.7 qt · 454.0 L | 359.3 qt · 340 L | +34% DT-200 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-200 sources
- Source: Traktorenlexikon, “AGCO DT 200”
- Source: Traktorenlexikon, “AGCO DT 180”
Fendt 820 Vario sources
- Source: Traktorenlexikon, “Fendt 820 Vario”
- Source: Traktorenlexikon, “Fendt 718 Vario”