2 material differences · fewer than 12
Tractor oneAgco DT-180 A2005–2008No measured PTO figureTractor twoMassey Ferguson MF 84502004–2008No measured PTO figure
Which should you choose?
Read our verdict on the DT-180 A and the MF 8450 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
2 material differences · 14 fields identical or within 5%, which is not counted as material
| Field | DT-180 A | MF 8450 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 212.0 hp | 212.1 hp | — |
| Engine declared | SISU-DIESEL 74 ETA | SISU-Power 74.288 ETA | differs |
| Displacement declared | 7.37 L | 7.37 L | — |
| Maximum torque declared | 645 lb·ft · 875 N·m | 638 lb·ft · 865 N·m | — |
| Transmission | |||
| Top speed declared | 24.9–31.1 mph · 40–50 km/h | 24.9–31.1 mph · 40–50 km/h | — |
| Clutch declared | Electro-hydraulically operated wet multi-disc PTO clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic control declared | Load sensing | Load sensing | — |
| Pump flow declared | 37.4 gpm · 141.5 L/min | 39.6 gpm · 150.0 L/min | +6% MF 8450 |
| Pressure declared | 2,176 psi · 150 bar | 2,176 psi · 150 bar | — |
| Rear PTO speeds declared | 540/1000/540E rpm | 540/1000/540E rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 19,908 lb · 9,030 kg | 19,930 lb · 9,040 kg | — |
| Maximum permissible mass declared | 30,865 lb · 14,000 kg | 30,865 lb · 14,000 kg | — |
| Wheelbase declared | 121.1 in · 3,075 mm | 121.1 in · 3,075 mm | — |
| Length declared | 206.3 in · 5,240 mm | 206.3 in · 5,240 mm | — |
| Width declared | 100.4 in · 2,550 mm | 100.4 in · 2,550 mm | — |
| Ground clearance declared | 18.5 in · 470 mm | 18.5 in · 470 mm | — |
| Fuel tank declared | 697.4 qt · 660.0 L | 697.4 qt · 660.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Agco DT-180 A sources
- Source: Traktorenlexikon, “AGCO DT 180 A”
Massey Ferguson MF 8450 sources
- Source: Traktorenlexikon, “Massey Ferguson MF 8450”