10 material differences · fewer than 12
Tractor oneAGCO-ALLIS 97651998–2001No measured PTO figureTractor twoJohn Deere 8100 T1997–1998No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (42%); the drive differs (Two-wheel or four-wheel drive; Tracks); the 8100 T is on tracks, not an alternative to an ordinary tractor. The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
10 material differences · 4 fields identical or within 5%, which is not counted as material
| Field | 9765 | 8100 T | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 182.5 hp | 182.6 hp | — |
| Engine declared | INTERNATIONAL-NAVISTAR DT-530 | John Deere-PowerTech 6.081 HRW-10 | differs |
| Displacement declared | — | 8.13 L | — |
| Maximum torque declared | — | 568 lb·ft · 770 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Oil-cooled wet multi-disc clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | Closed centre | — |
| Hydraulic control declared | — | Load sensing | — |
| Pump flow declared | — | 31.1 gpm · 117.7 L/min | — |
| Pressure declared | 3,046 psi · 210 bar | 3,379 psi · 233 bar | +11% 8100 T |
| Three-point lift, at the coupling points declared | 19,709 lb · 8,940 kg | 15,763 lb · 7,150 kg | +25% 9765 |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 17,200 lb · 7,802 kg | 24,471 lb · 11,100 kg | +42% 8100 T |
| Wheelbase declared | 112.5 in · 2,858 mm | 89.0 in · 2,260 mm | +26% 9765 |
| Length declared | 203.0 in · 5,156 mm | 216.0 in · 5,487 mm | +6% 8100 T |
| Width declared | 98.2 in · 2,494 mm | 102.0–109.3 in · 2,591–2,775 mm | differs |
| Height, over the cab declared | 121.0 in · 3,073 mm | 123.4 in · 3,135 mm | — |
| Ground clearance declared | 17.5 in · 445 mm | 14.2 in · 360 mm | +24% 9765 |
| Fuel tank declared | 479.7 qt · 454.0 L | 519.9 qt · 492.0 L | +8% 8100 T |
AGCO-ALLIS 9765 sources
Source
- Source: Traktorenlexikon, “AGCO-Allis 9765”
- Source: Traktorenlexikon, “AGCO-Allis 9755”
John Deere 8100 T sources
Source
- Source: Traktorenlexikon, “John Deere 8100T”
- Source: OECD test report 1780, 1998