8 material differences · fewer than 12
Tractor oneAGCO-ALLIS 96951994–1998No measured PTO figureTractor twoJ.I. Case 32941984–1985No measured PTO figure
Which should you choose?
Read our verdict on the 9695 and the 3294 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
8 material differences · 5 fields identical or within 5%, which is not counted as material
| Field | 9695 | 3294 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 195.3 hp | 194.3 hp | — |
| Engine declared | DETROIT-DIESEL DT-530 | CASE 504 BDT | differs |
| Displacement declared | 8.71 L | 8.26 L | +5% 9695 |
| Maximum torque declared | 654 lb·ft · 887 N·m | — | — |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 18.6 mph · 30 km/h | +33% 9695 |
| Clutch declared | Electro-hydraulically operated wet Funk multi-plate clutch type 9400 | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 20.6 gpm · 78.0 L/min | 23.0 gpm · 87.1 L/min | +12% 3294 |
| Pressure declared | 2,944 psi · 203 bar | — | — |
| Rear PTO speeds declared | 1000 rpm | 1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 18,592 lb · 8,433 kg | 17,915 lb · 8,126 kg | — |
| Wheelbase declared | 116.5 in · 2,959 mm | 104.0 in · 2,642 mm | +12% 9695 |
| Length declared | 200.0 in · 5,080 mm | 182.0 in · 4,623 mm | +10% 9695 |
| Width declared | 98.0–115.0 in · 2,489–2,921 mm | 96.0 in · 2,438 mm | differs |
| Ground clearance declared | 22.5 in · 572 mm | 22.5 in · 572 mm | — |
| Turning radius, braked declared | 14.8 ft · 4.50 m | 14.8 ft · 4.52 m | — |
| Fuel tank declared | 387.8 qt · 367.0 L | 259.9 qt · 246.0 L | +49% 9695 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 9695 sources
Source
- Source: Traktorenlexikon, “AGCO-Allis 9695”
- Source: Traktorenlexikon, “AGCO-Allis 9675”
J.I. Case 3294 sources
Source
- Source: Traktorenlexikon, “Case 3294”
- Source: Traktorenlexikon, “Case 2290”