13 material differences
Tractor oneAGCO-ALLIS 96751994–1998No measured PTO figureTractor twoNew Holland TM 175 (Traktorenlexikon)2002–2007No measured PTO figure
Which should you choose?
Read our verdict on the 9675 and the TM 175 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
13 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 9675 | TM 175 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 174.6 hp | 174.6 hp | — |
| Engine declared | DETROIT-DIESEL DT-530 | CASE-NEW HOLLAND 675-TA/FB | differs |
| Displacement declared | 8.71 L | 7.48 L | +16% 9675 |
| Maximum torque declared | 601 lb·ft · 815 N·m | 512 lb·ft · 694 N·m | +17% 9675 |
| Transmission | |||
| Top speed declared | 24.9 mph · 40 km/h | 24.9–31.1 mph · 40–50 km/h | differs |
| Clutch declared | electrohydraulically actuated wet FUNK multi-disc clutch | Electrohydraulically actuated wet multi-plate drive clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Closed centre | — | — |
| Pump flow declared | 28.1 gpm · 106.4 L/min | 27.0 gpm · 102.1 L/min | — |
| Pressure declared | — | 3,336 psi · 230 bar | — |
| Rear PTO speeds declared | 1000 rpm | 540E/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 14,559 lb · 6,604 kg | 15,796 lb · 7,165 kg | +8% TM 175 |
| Maximum permissible mass declared | — | 26,455 lb · 12,000 kg | — |
| Wheelbase declared | 123.2 in · 3,129 mm | 110.9 in · 2,818 mm | +11% 9675 |
| Length declared | 200.0 in · 5,080 mm | 233.7 in · 5,935 mm | +17% TM 175 |
| Width declared | 98.0–115.0 in · 2,489–2,921 mm | 98.2 in · 2,495 mm | differs |
| Ground clearance declared | 23.0 in · 584 mm | 15.2 in · 385 mm | +52% 9675 |
| Turning radius, braked declared | 13.8 ft · 4.20 m | 22.0 ft · 6.70 m | +60% TM 175 |
| Fuel tank declared | 387.8 qt · 367.0 L | 411.1 qt · 389.0 L | +6% TM 175 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 9675 sources
Source
- Source: Traktorenlexikon, “AGCO-Allis 9675”
New Holland TM 175 (Traktorenlexikon) sources
Source
- Source: Traktorenlexikon, “New Holland TM 175”