14 material differences

Tractor oneAGCO-ALLIS 96301993–1995No measured PTO figureTractor twoSOMECA 1380 (TD)1979–1983No measured PTO figure

Which should you choose?

Read our verdict on the 9630 and the 1380 (TD) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.

Field by field

14 material differences · 2 fields identical or within 5%, which is not counted as material

AGCO-ALLIS 9630 and SOMECA 1380 (TD), field by field
Field96301380 (TD)Gap
Engine
Engine power, claimed claimed133.2 hp133.2 hp—
Engine declaredK.H.D. BF6L 913 CFIAT-IVECO 8065.24.000differs
Displacement declared6.13 L5.50 L+11% 9630
Maximum torque declared393 lb·ft · 533 N·m347 lb·ft · 470 N·m+13% 9630
Transmission
Top speed declared24.9 mph · 40 km/h15.5–18.6 mph · 25–30 km/hdiffers
Clutch declaredHydraulically operated wet Funk multi-disc clutchPedal operated Ferodo or LuK single-disc clutchdiffers
Hydraulics & hitch
Hydraulic centre declaredClosed centre——
Pump flow declared22.6 gpm · 85.6 L/min14.1 gpm · 53.5 L/min+60% 9630
Pressure declared—3,263–3,408 psi · 225–235 bar—
Three-point lift, at the coupling points declared6,962 lb · 3,158 kg10,878 lb · 4,934 kg+56% 1380 (TD)
Rear PTO speeds declared540/1000 rpm1000 rpmdiffers
Weight & dimensions
Unladen weight declared14,802 lb · 6,714 kg10,748 lb · 4,875 kg+38% 9630
Maximum permissible mass declared—19,070 lb · 8,650 kg—
Wheelbase declared123.2 in · 3,129 mm108.3 in · 2,750 mm+14% 9630
Length declared187.5 in · 4,762 mm162.8 in · 4,135 mm+15% 9630
Width declared96.0–135.2 in · 2,438–3,435 mm85.0–108.7 in · 2,160–2,760 mmdiffers
Ground clearance declared23.0 in · 584 mm26.2 in · 665 mm+14% 1380 (TD)
Turning radius, braked declared13.8 ft · 4.20 m13.9 ft · 4.25 m—
Fuel tank declared267.9 qt · 253.5 L295.9 qt · 280.0 L+10% 1380 (TD)

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

AGCO-ALLIS 9630 sources

Source
  • Source: Traktorenlexikon, “AGCO-Allis 9630”

SOMECA 1380 (TD) sources

Source
  • Source: Traktorenlexikon, “Someca 1380”
  • Source: Traktorenlexikon, “Fiat 1380 (DT)”