11 material differences · fewer than 12

Tractor oneAGCO-ALLIS 96301993–1995No measured PTO figureTractor twoNew Holland 8360 A1996–1999No measured PTO figure

Which should you choose?

We will not advise between these two machines, because the drive differs (Two-wheel or four-wheel drive; 4WD); they were not built in overlapping years (1993–1995; 1996–1999). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

11 material differences · 3 fields identical or within 5%, which is not counted as material

AGCO-ALLIS 9630 and New Holland 8360 A, field by field
Field96308360 AGap
Engine
Engine power, claimed claimed133.2 hp133.2 hp—
Engine declaredK.H.D. BF6L 913 CNEW HOLLAND 675 T-WLdiffers
Displacement declared6.13 L7.48 L+22% 8360 A
Maximum torque declared393 lb·ft · 533 N·m420 lb·ft · 569 N·m+7% 8360 A
Transmission
Top speed declared24.9 mph · 40 km/h18.6–24.9 mph · 30–40 km/hdiffers
Clutch declaredHydraulically operated wet Funk multi-disc clutchElectro-hydraulic wet multi-disc clutchdiffers
Hydraulics & hitch
Hydraulic centre declaredClosed centre——
Pump flow declared22.6 gpm · 85.6 L/min25.7 gpm · 97.3 L/min+14% 8360 A
Pressure declared—2,799 psi · 193 bar—
Rear PTO speeds declared540/1000 rpm540/1000 rpm—
Weight & dimensions
Unladen weight declared14,802 lb · 6,714 kg13,062 lb · 5,925 kg+13% 9630
Maximum permissible mass declared—19,842 lb · 9,000 kg—
Wheelbase declared123.2 in · 3,129 mm107.2 in · 2,723 mm+15% 9630
Length declared187.5 in · 4,762 mm184.6 in · 4,690 mm—
Width declared96.0–135.2 in · 2,438–3,435 mm95.3 in · 2,420 mmdiffers
Ground clearance declared23.0 in · 584 mm15.0 in · 380 mm+54% 9630
Turning radius, braked declared13.8 ft · 4.20 m——
Fuel tank declared267.9 qt · 253.5 L232.5 qt · 220.0 L+15% 9630

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

AGCO-ALLIS 9630 sources

Source
  • Source: Traktorenlexikon, “AGCO-Allis 9630”

New Holland 8360 A sources

Source
  • Source: Traktorenlexikon, “New Holland 8360”