12 material differences
Tractor oneAGCO-ALLIS 87451998–1999No measured PTO figureTractor twoDeutz-Fahr 70 (F)2001–2005No measured PTO figure
Which should you choose?
Read our verdict on the 8745 and the 70 (F) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
12 material differences · 2 fields identical or within 5%, which is not counted as material
| Field | 8745 | 70 (F) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 69.1 hp | 69.1 hp | — |
| Engine declared | CUMMINS B 3.9 T | KHD F3L 913 | differs |
| Displacement declared | 3.93 L | 3.06 L | +28% 8745 |
| Maximum torque declared | — | 185 lb·ft · 251 N·m | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 24.9 mph · 40 km/h | +33% 70 (F) |
| Clutch declared | oil-cooled wet multi-plate clutch | Mechanically operated dry Borg & Beck single clutch, type: 305 | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 17.5 gpm · 66.2 L/min | 8.8 gpm · 33.5 L/min | +98% 8745 |
| Pressure declared | 3,046 psi · 210 bar | 2,176 psi · 150 bar | +40% 8745 |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm / 1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 7,970 lb · 3,615 kg | 5,115 lb · 2,320 kg | +56% 8745 |
| Wheelbase declared | 98.8 in · 2,510 mm | 82.8 in · 2,104 mm | +19% 8745 |
| Length declared | 161.0 in · 4,089 mm | 150.1 in · 3,812 mm | +7% 8745 |
| Width declared | 78.0 in · 1,981 mm | 82.7 in · 2,100 mm | +6% 70 (F) |
| Ground clearance declared | — | 14.4 in · 365 mm | — |
| Fuel tank declared | 147.9 qt · 140.0 L | 59.2 qt · 56 L | +150% 8745 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 8745 sources
Source
- Source: Traktorenlexikon, “AGCO-Allis 8745”
- Source: Traktorenlexikon, “White 6410”
Deutz-Fahr 70 (F) sources
Source
- Source: Traktorenlexikon, “Deutz-Fahr Agrolux 70”
- Source: Traktorenlexikon, “Fendt Farmer 260 S/SA”