7 material differences · fewer than 12
Tractor oneAGCO-ALLIS 76301991–1992No measured PTO figureTractor twoDEUTZ-ALLIS 71201986–1989No measured PTO figure
Which should you choose?
Read our verdict on the 7630 and the 7120 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
7 material differences · 8 fields identical or within 5%, which is not counted as material
| Field | 7630 | 7120 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 122.3 hp | 122.3 hp | — |
| Engine declared | S.L.H. 1056 P | K.H.D. BF6L 913 T | differs |
| Displacement declared | 6.24 L | 6.13 L | — |
| Maximum torque declared | 310 lb·ft · 420 N·m | — | — |
| Transmission | |||
| Top speed declared | 18.6 mph · 30 km/h | 18.6 mph · 30 km/h | — |
| Clutch declared | Pedal-operated dry S.L.H. double clutch | dry single clutch | differs |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | Open centre | — |
| Pump flow declared | 16.9 gpm · 64.0 L/min | 24.0 gpm · 90.8 L/min | +42% 7120 |
| Pressure declared | 3,046 psi · 210 bar | 3,481 psi · 240 bar | +14% 7120 |
| Rear PTO speeds declared | 540/1000 rpm | 540/1000 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 11,398 lb · 5,170 kg | 11,244 lb · 5,100 kg | — |
| Maximum permissible mass declared | 17,857 lb · 8,100 kg | — | — |
| Wheelbase declared | 110.0 in · 2,794 mm | 105.8 in · 2,687 mm | — |
| Length declared | 176.8 in · 4,491 mm | 179.5 in · 4,560 mm | — |
| Width declared | 86.8 in · 2,205 mm | 93.3 in · 2,370 mm | +7% 7120 |
| Ground clearance declared | 21.6 in · 549 mm | 24.4 in · 620 mm | +13% 7120 |
| Turning radius, braked declared | 11.5 ft · 3.52 m | — | — |
| Fuel tank declared | 221.9 qt · 210.0 L | 159.6 qt · 151.0 L | +39% 7630 |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 7630 sources
Source
- Source: Traktorenlexikon, “AGCO-Allis 7630”
DEUTZ-ALLIS 7120 sources
Source
- Source: Traktorenlexikon, “Deutz-Allis 7120”