13 material differences

Tractor oneAGCO-ALLIS 56801991–1997No measured PTO figureTractor twoURSUS 932/9341990–2003No measured PTO figure

Which should you choose?

We will not advise between these two machines, because their unladen weight differs by more than 25% (40%). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.

Field by field

13 material differences · 5 fields identical or within 5%, which is not counted as material

AGCO-ALLIS 5680 and URSUS 932/934, field by field
Field5680932/934Gap
Engine
Engine power, claimed claimed78.9 hp78.9 hp—
Engine declaredS.L.H. 1000.4 A-1Z.T.S.-MARTIN Z-8401.12differs
Displacement declared4.00 L4.56 L+14% 932/934
Maximum torque declared193 lb·ft · 261 N·m187 lb·ft · 254 N·m—
Transmission
Top speed declared18.6–24.9 mph · 30–40 km/h18.6 mph · 30 km/hdiffers
Clutch declaredPedal-operated dry SAME double clutchPedal-operated dry single-disc clutchdiffers
Hydraulics & hitch
Hydraulic centre declaredOpen centre——
Pump flow declared10.7 gpm · 40.5 L/min11.9 gpm · 45.2 L/min+12% 932/934
Pressure declared3,046 psi · 210 bar2,828 psi · 195 bar+8% 5680
Three-point lift, at the coupling points declared6,790 lb · 3,080 kg9,054 lb · 4,107 kg+33% 932/934
Rear PTO speeds declared540/1000 rpm540/1000 rpm—
Weight & dimensions
Unladen weight declared6,669 lb · 3,025 kg9,348 lb · 4,240 kg+40% 932/934
Maximum permissible mass declared11,464 lb · 5,200 kg16,314 lb · 7,400 kg+42% 932/934
Wheelbase declared92.9 in · 2,360 mm94.0 in · 2,387 mm—
Length declared154.3 in · 3,919 mm162.6 in · 4,130 mm+5% 932/934
Width declared76.4–97.0 in · 1,941–2,464 mm77.4–93.7 in · 1,966–2,380 mm—
Ground clearance declared19.7 in · 500 mm13.6 in · 345 mm+45% 5680
Turning radius, braked declared9.2 ft · 2.80 m11.7 ft · 3.58 m+28% 932/934
Fuel tank declared83.5 qt · 79.0 L95.1 qt · 90.0 L+14% 932/934

Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.

AGCO-ALLIS 5680 sources

Source
  • Source: Traktorenlexikon, “AGCO-Allis 5680”

URSUS 932/934 sources

Source
  • Source: Traktorenlexikon, “Ursus 932/934”