10 material differences · fewer than 12
Tractor oneAGCO-ALLIS 56601994–1999No measured PTO figureTractor twoMassey Ferguson MF 360 (A)1987–1994No measured PTO figure
Which should you choose?
Read our verdict on the 5660 and the MF 360 (A) → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
10 material differences · 3 fields identical or within 5%, which is not counted as material
| Field | 5660 | MF 360 (A) | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 57.3 hp | 57.3 hp | — |
| Engine declared | S.L.H. 1000.3 AT | Perkins AT 3.152-4 | differs |
| Displacement declared | 3.00 L | 2.50 L | +20% 5660 |
| Maximum torque declared | 137 lb·ft · 186 N·m | 134 lb·ft · 182 N·m | — |
| Transmission | |||
| Top speed declared | 18.6–24.9 mph · 30–40 km/h | 18.6 mph · 30 km/h | differs |
| Clutch declared | Dry SAME double clutch | — | — |
| Hydraulics & hitch | |||
| Hydraulic centre declared | Open centre | — | — |
| Pump flow declared | 9.5 gpm · 36.0 L/min | 5.0 gpm · 18.9 L/min | +90% 5660 |
| Pressure declared | 1,305 psi · 90 bar | — | — |
| Rear PTO speeds declared | 540/1000 rpm | 540 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 4,993 lb · 2,265 kg | 5,124 lb · 2,324 kg | — |
| Wheelbase declared | 82.9 in · 2,106 mm | 76.1 in · 1,933 mm | +9% 5660 |
| Length declared | 141.3 in · 3,589 mm | 129.1 in · 3,280 mm | +9% 5660 |
| Width declared | 72.6–88.4 in · 1,844–2,245 mm | 69.3 in · 1,760 mm | differs |
| Ground clearance declared | 19.7 in · 500 mm | 8.9 in · 227 mm | +120% 5660 |
| Turning radius, braked declared | 9.5 ft · 2.90 m | — | — |
| Fuel tank declared | 60.2 qt · 57.0 L | 71.9 qt · 68 L | +19% MF 360 (A) |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
AGCO-ALLIS 5660 sources
- Source: Traktorenlexikon, “AGCO-Allis 5660”
Massey Ferguson MF 360 (A) sources
- Source: Traktorenlexikon, “Massey Ferguson MF 360”
- Source: Traktorenlexikon, “Massey Ferguson MF 253”