AGCO-ALLIS 5660 or Case-IH JX 60 (A)?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 5660 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the JX 60 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 5660 | JX 60 (A) | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 42.7 kW (57.3 hp)Traktorenlexikon, “AGCO-Allis 5660” | 43.4 kW (58.2 hp)Traktorenlexikon, “Case-IH JX60” | Not comparableNot comparable on power at the PTO shaft: the 5660 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the JX 60 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 5660 and the JX 60 (A). |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 5660 and the JX 60 (A). |
| Which pumps more oil for implements? | 36.0 L/min (9.5 gpm)Traktorenlexikon, “AGCO-Allis 5660” | — | No figureNo call on hydraulic flow: no figure on record for the JX 60 (A). |
| Which lifts more on the three-point hitch? | 2,055 kg (4,530 lb)Traktorenlexikon, “AGCO-Allis 5660” | 2,937 kg (6,475 lb)Traktorenlexikon, “Case-IH JX60” | Not comparableNot comparable on three-point lift: the 5660: lift through the full range 610 mm behind the ends, as stated by the source (Traktorenlexikon, “AGCO-Allis 5660”); the JX 60 (A): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Case-IH JX60”) — not the same quantity, basis and condition. |
| Which is heavier, for traction? | 2,265 kg (4,993 lb)Traktorenlexikon, “AGCO-Allis 5660” | 2,590 kg (5,710 lb)Traktorenlexikon, “Case-IH JX60” | Ahead (a fact, not an advantage)The Case-IH JX 60 (A) is 14% heavier (325 kg / 717 lb) than the AGCO-ALLIS 5660 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 5660 and the JX 60 (A). |
| Which has the wider choice of gears? | 12 to 16Traktorenlexikon, “AGCO-Allis 5660” | 12 to 20Traktorenlexikon, “Case-IH JX60” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 5660 and the JX 60 (A). |
| Which is faster on the road? | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “AGCO-Allis 5660” | 30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Case-IH JX60” | EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers more PTO speeds? | 540/1000 rpmTraktorenlexikon, “AGCO-Allis 5660” | 540E/540/1000 rpmTraktorenlexikon, “Case-IH JX60” | EvenEven on PTO speeds: the same speeds (540, 1000 rpm). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “AGCO-Allis 5660” | independentTraktorenlexikon, “Case-IH JX60” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “AGCO-Allis 5660” | 2WD / 4WDTraktorenlexikon, “Case-IH JX60” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1994–1999 | 2004–2008 | Ahead (a fact, not an advantage)The Case-IH JX 60 (A) is newer: production began 10 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The Case-IH JX 60 (A) is 14% heavier (325 kg / 717 lb) than the AGCO-ALLIS 5660 (both unladen weight, as stated by the source).
- The Case-IH JX 60 (A) is newer: production began 10 years later. We hold no parts-availability data, so there is no call on parts.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on PTO speeds: the same speeds (540, 1000 rpm).
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the 5660 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the JX 60 (A) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- Not comparable on three-point lift: the 5660: lift through the full range 610 mm behind the ends, as stated by the source (Traktorenlexikon, “AGCO-Allis 5660”); the JX 60 (A): lift at the hitch ends, as stated by the source (Traktorenlexikon, “Case-IH JX60”) — not the same quantity, basis and condition.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources