AGCO-ALLIS 4650 or DEUTZ-ALLIS 6250?
Which should you choose?
The data can’t decide this. Power at the PTO shaft cannot be compared: the 4650 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 6250 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- The DEUTZ-ALLIS 6250 suits loader and hydraulic implement work better on this data: 54% (15.4 L/min / 4.1 gpm) more hydraulic flow and 14% (300 kg / 661 lb) more three-point lift.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 4650 | 6250 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 36.8 kW (49.3 hp)Traktorenlexikon, “AGCO-Allis 4650” | 37.5 kW (50.3 hp)Traktorenlexikon, “Deutz-Allis 6250” | Not comparableNot comparable on power at the PTO shaft: the 4650 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 6250 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 4650 and the 6250. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 4650 and the 6250. |
| Which pumps more oil for implements? | 28.5 L/min (7.5 gpm)Traktorenlexikon, “AGCO-Allis 4650” | 43.9 L/min (11.6 gpm)Traktorenlexikon, “Deutz-Allis 6250” | AheadThe DEUTZ-ALLIS 6250 has 54% more hydraulic flow (15.4 L/min / 4.1 gpm) than the AGCO-ALLIS 4650 (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 2,100 kg (4,630 lb)Traktorenlexikon, “AGCO-Allis 4650” | 2,400 kg (5,291 lb)Traktorenlexikon, “Deutz-Allis 6250” | AheadThe DEUTZ-ALLIS 6250 has 14% more lift (300 kg / 661 lb) than the AGCO-ALLIS 4650 (both lift at the hitch ends, as stated by the source). |
| Which is heavier, for traction? | 2,030 kg (4,475 lb)Traktorenlexikon, “AGCO-Allis 4650” | 2,730 kg (6,019 lb)Traktorenlexikon, “Deutz-Allis 6250” | Ahead (a fact, not an advantage)The DEUTZ-ALLIS 6250 is 34% heavier (700 kg / 1,543 lb) than the AGCO-ALLIS 4650 (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | 5,000 kg (11,023 lb)Traktorenlexikon, “Deutz-Allis 6250” | No figureNo call on maximum permissible mass: no figure on record for the 4650. |
| Which has the wider choice of gears? | 12 to 16Traktorenlexikon, “AGCO-Allis 4650” | 8 to 16Traktorenlexikon, “Deutz-Allis 6250” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 4650 and the 6250. |
| Which is faster on the road? | 30 km/h (18.6 mph)Traktorenlexikon, “AGCO-Allis 4650” | 30 km/h (18.6 mph)Traktorenlexikon, “Deutz-Allis 6250” | EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call. |
| Which offers more PTO speeds? | 540 rpmTraktorenlexikon, “AGCO-Allis 4650” | 540/1000 rpmTraktorenlexikon, “Deutz-Allis 6250” | AheadThe DEUTZ-ALLIS 6250 offers 1000 rpm at the PTO, which the AGCO-ALLIS 4650 does not (as stated by the sources). |
| Which PTO runs independently of the ground drive? | independentTraktorenlexikon, “AGCO-Allis 4650” | independentTraktorenlexikon, “Deutz-Allis 6250” | EvenEven on PTO independence: every PTO is independent. |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “AGCO-Allis 4650” | Two-wheel or four-wheel driveTraktorenlexikon, “Deutz-Allis 6250” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1991–1997 | 1986–1990 | Ahead (a fact, not an advantage)The AGCO-ALLIS 4650 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The DEUTZ-ALLIS 6250 has 54% more hydraulic flow (15.4 L/min / 4.1 gpm) than the AGCO-ALLIS 4650 (both pump flow, as stated by the source).
- The DEUTZ-ALLIS 6250 has 14% more lift (300 kg / 661 lb) than the AGCO-ALLIS 4650 (both lift at the hitch ends, as stated by the source).
- The DEUTZ-ALLIS 6250 is 34% heavier (700 kg / 1,543 lb) than the AGCO-ALLIS 4650 (both unladen weight, as stated by the source).
- The DEUTZ-ALLIS 6250 offers 1000 rpm at the PTO, which the AGCO-ALLIS 4650 does not (as stated by the sources).
- The AGCO-ALLIS 4650 is newer: production began 5 years later. We hold no parts-availability data, so there is no call on parts.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
- Even on PTO independence: every PTO is independent.
- Even on drive: every machine is available with four-wheel drive.
- Not comparable on power at the PTO shaft: the 4650 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 6250 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass and a creeper range.
← Every figure for both machines, side by side, with sources