7 material differences · fewer than 12
Tractor oneAebi TT 241from 2016No measured PTO figureTractor twoClaas Celtis 4262003–2008No measured PTO figure
Which should you choose?
We will not advise between these two machines, because their unladen weight differs by more than 25% (33%); they were not built in overlapping years (2016–2016; 2003–2008). The figures below are side by side so you can judge them yourself; each says whether it was measured, claimed or declared by its source.
Field by field
7 material differences · 1 fields identical or within 5%, which is not counted as material
| Field | TT 241 | Celtis 426 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 74 hp | 74 hp | — |
| Maximum torque declared | 229 lb·ft · 310 N·m | 209 lb·ft · 283 N·m | +10% TT 241 |
| Transmission | |||
| Top speed declared | — | 24.9 mph · 40 km/h | — |
| Clutch declared | Electro-hydraulic single-disc clutch | — | — |
| Hydraulics & hitch | |||
| Pump flow declared | 10.6 gpm · 40 L/min | 18.2 gpm · 69 L/min | +73% Celtis 426 |
| Pressure declared | 2,901 psi · 200 bar | 2,611 psi · 180 bar | +11% TT 241 |
| Rear PTO speeds declared | 540 rpm / 750 rpm / 1000 rpm | 540/1000 rpm | differs |
| Weight & dimensions | |||
| Unladen weight declared | 6,173 lb · 2,800 kg | 8,223 lb · 3,730 kg | +33% Celtis 426 |
| Maximum permissible mass declared | 9,921 lb · 4,500 kg | — | — |
| Wheelbase declared | — | 98.0 in · 2,489 mm | — |
| Length declared | 161.0 in · 4,090 mm | 149.8 in · 3,805 mm | +7% TT 241 |
| Width declared | 83.1 in · 2,110 mm | 98.8 in · 2,510 mm | +19% Celtis 426 |
| Ground clearance declared | — | 15.0 in · 380 mm | — |
| Fuel tank declared | — | 153.2 qt · 145 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
Aebi TT 241 sources
- Source: Traktorenlexikon, “Aebi TT 241”
Claas Celtis 426 sources
- Source: Traktorenlexikon, “Claas Celtis 426”
- Source: OECD test report 2219, 2005