Steyr 8100 (a) or Steyr 9086 (a)?

Which should you choose?

On performance, every comparable figure that differs favours the Steyr 9086 (a): hydraulic flow and three-point lift.

  • The Steyr 9086 (a) suits loader and hydraulic implement work better on this data: 50% (17.8 L/min / 4.7 gpm) more hydraulic flow and 12% (487 kg / 1,074 lb) more three-point lift.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Steyr 8100 (a) and Steyr 9086 (a), with the call on each
Question8100 (a)9086 (a)Call
Which puts more power through the PTO shaft?56.9 kW (76.3 hp)Traktorenlexikon, “Steyr 8100”56.9 kW (76.3 hp)Traktorenlexikon, “Steyr 9086”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?No figureNo call on fuel efficiency at the shaft: no figure on record for the 8100 (a) and the 9086 (a).
Which pulls harder at the drawbar?No figureNo call on drawbar power: no figure on record for the 8100 (a) and the 9086 (a).
Which pumps more oil for implements?35.5 L/min (9.4 gpm)Traktorenlexikon, “Steyr 8100”53.3 L/min (14.1 gpm)Traktorenlexikon, “Steyr 9086”AheadThe Steyr 9086 (a) has 50% more hydraulic flow (17.8 L/min / 4.7 gpm) than the Steyr 8100 (a) (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?4,063 kg (8,957 lb)Traktorenlexikon, “Steyr 8100”4,550 kg (10,031 lb)Traktorenlexikon, “Steyr 9086”AheadThe Steyr 9086 (a) has 12% more lift (487 kg / 1,074 lb) than the Steyr 8100 (a) (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?3,672 kg (8,095 lb)Traktorenlexikon, “Steyr 8100”3,530 kg (7,782 lb)Traktorenlexikon, “Steyr 9086”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?6,500 kg (14,330 lb)Traktorenlexikon, “Steyr 9086”No figureNo call on maximum permissible mass: no figure on record for the 8100 (a).
Which has the wider choice of gears?12 to 20Traktorenlexikon, “Steyr 8100”16 to 32Traktorenlexikon, “Steyr 9086”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?No figureNo call on a creeper range: not stated for the 8100 (a) and the 9086 (a).
Which is faster on the road?25 km/h (15.5 mph) to 30 km/h (18.6 mph)Traktorenlexikon, “Steyr 8100”30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Steyr 9086”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Steyr 8100”390/540/1000 rpmTraktorenlexikon, “Steyr 9086”EvenEven on PTO speeds: the same speeds (540, 1000 rpm).
Which PTO runs independently of the ground drive?independentTraktorenlexikon, “Steyr 8100”No figureNo call on PTO independence: not stated for the 9086 (a).
Which drives on both axles?2WD / 4WDTraktorenlexikon, “Steyr 8100”2WD / 4WDTraktorenlexikon, “Steyr 9086”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1978–19841993–1995Ahead (a fact, not an advantage)The Steyr 9086 (a) is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Steyr 9086 (a) has 50% more hydraulic flow (17.8 L/min / 4.7 gpm) than the Steyr 8100 (a) (both pump flow, as stated by the source).
  • The Steyr 9086 (a) has 12% more lift (487 kg / 1,074 lb) than the Steyr 8100 (a) (both lift at the hitch ends, as stated by the source).
  • The Steyr 9086 (a) is newer: production began 15 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on PTO speeds: the same speeds (540, 1000 rpm).
  • Even on drive: every machine is available with four-wheel drive.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources