Steyr 8060 (a) or WHITE 2-45?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 8060 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2-45 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

  • The Steyr 8060 (a) suits loader and hydraulic implement work better on this data: 45% (678 kg / 1,495 lb) more three-point lift.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Steyr 8060 (a) and WHITE 2-45, with the call on each
Question8060 (a)2-45Call
Which puts more power through the PTO shaft?35.3 kW (47.3 hp)Traktorenlexikon, “Steyr 8060”35.3 kW (47.3 hp)Traktorenlexikon, “White 2-45”Not comparableNot comparable on power at the PTO shaft: the 8060 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2-45 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the 8060 (a) and the 2-45.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the 8060 (a) and the 2-45.
Which pumps more oil for implements?24.1 L/min (6.4 gpm)Traktorenlexikon, “Steyr 8060”—No figureNo call on hydraulic flow: no figure on record for the 2-45.
Which lifts more on the three-point hitch?2,200 kg (4,850 lb)Traktorenlexikon, “Steyr 8060”1,522 kg (3,355 lb)Traktorenlexikon, “White 2-45”AheadThe Steyr 8060 (a) has 45% more lift (678 kg / 1,495 lb) than the WHITE 2-45 (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?2,420 kg (5,335 lb)Traktorenlexikon, “Steyr 8060”2,365 kg (5,214 lb)Traktorenlexikon, “White 2-45”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the 8060 (a) and the 2-45.
Which has the wider choice of gears?16Traktorenlexikon, “Steyr 8060”20Traktorenlexikon, “White 2-45”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?—YesTraktorenlexikon, “White 2-45”No figureNo call on a creeper range: not stated for the 8060 (a).
Which is faster on the road?30 km/h (18.6 mph) to 40 km/h (24.9 mph)Traktorenlexikon, “Steyr 8060”30 km/h (18.6 mph)Traktorenlexikon, “White 2-45”EvenEven on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers more PTO speeds?540/1000 rpmTraktorenlexikon, “Steyr 8060”540 rpmTraktorenlexikon, “White 2-45”AheadThe Steyr 8060 (a) offers 1000 rpm at the PTO, which the WHITE 2-45 does not (as stated by the sources).
Which PTO runs independently of the ground drive?——No figureNo call on PTO independence: not stated for the 8060 (a) and the 2-45.
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Steyr 8060”Two-wheel or four-wheel driveTraktorenlexikon, “White 2-45”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1979–19921980–1981EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Steyr 8060 (a) has 45% more lift (678 kg / 1,495 lb) than the WHITE 2-45 (both lift at the hitch ends, as stated by the source).
  • The Steyr 8060 (a) offers 1000 rpm at the PTO, which the WHITE 2-45 does not (as stated by the sources).
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 8060 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the 2-45 has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources