Steyr 545 (a) or WARCHALOWSKI-MC CORMICK WT-45 A?

Which should you choose?

The data can’t decide this. Power at the PTO shaft cannot be compared: the 545 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the WT-45 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Steyr 545 (a) and WARCHALOWSKI-MC CORMICK WT-45 A, with the call on each
Question545 (a)WT-45 ACall
Which puts more power through the PTO shaft?33.1 kW (44.4 hp)Traktorenlexikon, “Steyr 545”33.1 kW (44.4 hp)Traktorenlexikon, “Warchalowski WT 45 A”Not comparableNot comparable on power at the PTO shaft: the 545 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the WT-45 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the 545 (a) and the WT-45 A.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the 545 (a) and the WT-45 A.
Which pumps more oil for implements?——No figureNo call on hydraulic flow: no figure on record for the 545 (a) and the WT-45 A.
Which lifts more on the three-point hitch?1,850 kg (4,079 lb)Traktorenlexikon, “Steyr 545”1,800 kg (3,968 lb)Traktorenlexikon, “Warchalowski WT 45 A”EvenEven on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
Which is heavier, for traction?1,890 kg (4,167 lb)Traktorenlexikon, “Steyr 545”1,950 kg (4,299 lb)Traktorenlexikon, “Warchalowski WT 45 A”EvenEven on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the 545 (a) and the WT-45 A.
Which has the wider choice of gears?8 to 16Traktorenlexikon, “Steyr 545”8Traktorenlexikon, “Warchalowski WT 45 A”EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
Which offers a creeper range?——No figureNo call on a creeper range: not stated for the 545 (a) and the WT-45 A.
Which is faster on the road?30 km/h (18.6 mph)Traktorenlexikon, “Steyr 545”30 km/h (18.6 mph)Traktorenlexikon, “Warchalowski WT 45 A”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpm / 1000 rpmTraktorenlexikon, “Steyr 545”540 rpmTraktorenlexikon, “Warchalowski WT 45 A”AheadThe Steyr 545 (a) offers 1000 rpm at the PTO, which the WARCHALOWSKI-MC CORMICK WT-45A does not (as stated by the sources).
Which PTO runs independently of the ground drive?—independentTraktorenlexikon, “Warchalowski WT 45 A”No figureNo call on PTO independence: not stated for the 545 (a).
Which drives on both axles?Two-wheel or four-wheel driveTraktorenlexikon, “Steyr 545”4WDTraktorenlexikon, “Warchalowski WT 45 A”EvenEven on drive: every machine is available with four-wheel drive.
Which is newer, and what about parts?1972–19771968–1970EvenSame era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The Steyr 545 (a) offers 1000 rpm at the PTO, which the WARCHALOWSKI-MC CORMICK WT-45A does not (as stated by the sources).
  • Even on three-point lift (both lift at the hitch ends, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on weight (both unladen weight, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on drive: every machine is available with four-wheel drive.
  • Same era: production began within 5 years of each other. We hold no parts-availability data, so there is no call on parts.
  • Not comparable on power at the PTO shaft: the 545 (a) has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft; the WT-45 A has only engine power (gross or net not stated), claimed — a different quantity from power at the shaft.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, hydraulic flow, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources