Steyr 185 a or URSUS C-355 P?

Which should you choose?

On performance, every comparable figure that differs favours the URSUS C-355P: hydraulic flow and three-point lift.

  • The URSUS C-355P suits loader and hydraulic implement work better on this data: 43% (6.0 L/min / 1.6 gpm) more hydraulic flow and 64% (700 kg / 1,543 lb) more three-point lift.

Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.

What decides it, question by question?

Buyer questions for Steyr 185 a and URSUS C-355 P, with the call on each
Question185 aC-355 PCall
Which puts more power through the PTO shaft?35.8 kW (48.0 hp)Traktorenlexikon, “Steyr 185a”36.0 kW (48.3 hp)Traktorenlexikon, “Ursus C-355”EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
Which turns a litre of fuel into more work at the shaft?——No figureNo call on fuel efficiency at the shaft: no figure on record for the 185 a and the C-355 P.
Which pulls harder at the drawbar?——No figureNo call on drawbar power: no figure on record for the 185 a and the C-355 P.
Which pumps more oil for implements?14.0 L/min (3.7 gpm)Traktorenlexikon, “Steyr 185a”20.0 L/min (5.3 gpm)Traktorenlexikon, “Ursus C-355”AheadThe URSUS C-355P has 43% more hydraulic flow (6.0 L/min / 1.6 gpm) than the Steyr 185a (both pump flow, as stated by the source).
Which lifts more on the three-point hitch?1,100 kg (2,425 lb)Traktorenlexikon, “Steyr 185a”1,800 kg (3,968 lb)Traktorenlexikon, “Ursus C-355”AheadThe URSUS C-355P has 64% more lift (700 kg / 1,543 lb) than the Steyr 185a (both lift at the hitch ends, as stated by the source).
Which is heavier, for traction?2,800 kg (6,173 lb)Traktorenlexikon, “Steyr 185a”2,201 kg (4,852 lb)Traktorenlexikon, “Ursus C-355”Ahead (a fact, not an advantage)The Steyr 185a is 27% heavier (599 kg / 1,321 lb) than the URSUS C-355P (both unladen weight, as stated by the source).
Which may carry more ballast and load?——No figureNo call on maximum permissible mass: no figure on record for the 185 a and the C-355 P.
Which has the wider choice of gears?6 to 9Traktorenlexikon, “Steyr 185a”10Traktorenlexikon, “Ursus C-355”EvenEven on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
Which offers a creeper range?YesTraktorenlexikon, “Steyr 185a”—No figureNo call on a creeper range: not stated for the C-355 P.
Which is faster on the road?25 km/h (15.5 mph)Traktorenlexikon, “Steyr 185a”25 km/h (15.5 mph)Traktorenlexikon, “Ursus C-355”EvenEven on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
Which offers more PTO speeds?540 rpmTraktorenlexikon, “Steyr 185a”540 rpmTraktorenlexikon, “Ursus C-355”EvenEven on PTO speeds: the same speeds (540 rpm).
Which PTO runs independently of the ground drive?—independentTraktorenlexikon, “Ursus C-355”No figureNo call on PTO independence: not stated for the 185 a.
Which drives on both axles?2WDTraktorenlexikon, “Steyr 185a”2WDTraktorenlexikon, “Ursus C-355”EvenEven on drive: all two-wheel drive.
Which is newer, and what about parts?1958–19671971–1975Ahead (a fact, not an advantage)The URSUS C-355P is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts.

What does this mean in plain words?

  • The URSUS C-355P has 43% more hydraulic flow (6.0 L/min / 1.6 gpm) than the Steyr 185a (both pump flow, as stated by the source).
  • The URSUS C-355P has 64% more lift (700 kg / 1,543 lb) than the Steyr 185a (both lift at the hitch ends, as stated by the source).
  • The Steyr 185a is 27% heavier (599 kg / 1,321 lb) than the URSUS C-355P (both unladen weight, as stated by the source).
  • The URSUS C-355P is newer: production began 13 years later. We hold no parts-availability data, so there is no call on parts.
  • Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
  • Even on forward gears (both forward gears, as stated by the source): the difference is under the 25% threshold, too small to call.
  • Even on top speed (both top speed forward, as stated by the source): the difference is under the 10% threshold, too small to call.
  • Even on PTO speeds: the same speeds (540 rpm).
  • Even on drive: all two-wheel drive.
  • No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, maximum permissible mass, a creeper range and PTO independence.

← Every figure for both machines, side by side, with sources