4 material differences · fewer than 12
Tractor oneSOMECA SOM-35 GD1961–1963No measured PTO figureTractor twoSOMECA SOM-481 GD1964–1965No measured PTO figure
Which should you choose?
Read our verdict on the SOM-35 GD and the SOM-481 GD → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
4 material differences · 11 fields identical or within 5%, which is not counted as material
| Field | SOM-35 GD | SOM-481 GD | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 40.5 hp | 40.5 hp | — |
| Engine declared | O.M.-FIAT 615.000 | O.M.-FIAT 615.000 | — |
| Displacement declared | 2.27 L | 2.27 L | — |
| Maximum torque declared | 103 lb·ft · 140 N·m | 101 lb·ft · 137 N·m | — |
| Transmission | |||
| Top speed declared | 13.7 mph · 22 km/h | 13.7 mph · 22 km/h | — |
| Clutch declared | Pedal-operated two-stage dry double clutch | Pedal-operated dry double clutch | differs |
| Hydraulics & hitch | |||
| Pump flow declared | 4.4 gpm · 16.5 L/min | 4.4 gpm · 16.5 L/min | — |
| Pressure declared | 2,843 psi · 196 bar | 2,843 psi · 196 bar | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 3,439 lb · 1,560 kg | 3,726 lb · 1,690 kg | +8% SOM-481 GD |
| Wheelbase declared | 84.6 in · 2,150 mm | 85.4 in · 2,170 mm | — |
| Length declared | 126.8 in · 3,220 mm | 126.8 in · 3,220 mm | — |
| Width declared | 62.2 in · 1,580 mm | 59.1–86.6 in · 1,500–2,200 mm | differs |
| Ground clearance declared | 23.2 in · 590 mm | 23.2 in · 590 mm | — |
| Fuel tank declared | 41.2 qt · 39.0 L | 51.8 qt · 49.0 L | +26% SOM-481 GD |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SOMECA SOM-35 GD sources
- Source: Traktorenlexikon, “Someca SOM 35 GD”
- Source: Traktorenlexikon, “Someca SOM 35”
SOMECA SOM-481 GD sources
- Source: Traktorenlexikon, “Someca SOM 481”
- Source: Traktorenlexikon, “Someca SOM 35”