SOMECA 850 (TD) or VALMET 705/705-4?
Which should you choose?
On performance, every comparable figure that differs favours the VALMET 705/705-4: hydraulic flow. It is also ahead on top speed.
- The VALMET 705/705-4 suits loader and hydraulic implement work better on this data: 26% (10.0 L/min / 2.6 gpm) more hydraulic flow.
- The VALMET 705/705-4 suits road haulage better on this data: 20% (5.0 km/h / 3.1 mph) more top speed.
Generated by rule set compare@4 from the figures on the side-by-side table, allowed by route “the same stated configuration”. Measured figures are compared only with measured, claimed only with claimed, at the same test condition; differences within each figure’s tolerance are not called.
What decides it, question by question?
| Question | 850 (TD) | 705/705-4 | Call |
|---|---|---|---|
| Which puts more power through the PTO shaft? | 57.1 kW (76.6 hp)Traktorenlexikon, “Someca 850” | 57.4 kW (77.0 hp)Traktorenlexikon, “Valmet 705” | EvenEven on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call. |
| Which turns a litre of fuel into more work at the shaft? | — | — | No figureNo call on fuel efficiency at the shaft: no figure on record for the 850 (TD) and the 705/705-4. |
| Which pulls harder at the drawbar? | — | — | No figureNo call on drawbar power: no figure on record for the 850 (TD) and the 705/705-4. |
| Which pumps more oil for implements? | 38.0 L/min (10.0 gpm)Traktorenlexikon, “Someca 850” | 48.0 L/min (12.7 gpm)Traktorenlexikon, “Valmet 705” | AheadThe VALMET 705/705-4 has 26% more hydraulic flow (10.0 L/min / 2.6 gpm) than the SOMECA 850 (TD) (both pump flow, as stated by the source). |
| Which lifts more on the three-point hitch? | 2,712 kg (5,979 lb)Traktorenlexikon, “Someca 850” | — | No figureNo call on three-point lift: no figure on record for the 705/705-4. |
| Which is heavier, for traction? | 3,195 kg (7,044 lb)Traktorenlexikon, “Someca 850” | 3,790 kg (8,356 lb)Traktorenlexikon, “Valmet 705” | Ahead (a fact, not an advantage)The VALMET 705/705-4 is 19% heavier (595 kg / 1,312 lb) than the SOMECA 850 (TD) (both unladen weight, as stated by the source). |
| Which may carry more ballast and load? | — | — | No figureNo call on maximum permissible mass: no figure on record for the 850 (TD) and the 705/705-4. |
| Which has the wider choice of gears? | 12 to 16Traktorenlexikon, “Someca 850” | 8 to 16Traktorenlexikon, “Valmet 705” | EvenEven on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap. |
| Which offers a creeper range? | — | — | No figureNo call on a creeper range: not stated for the 850 (TD) and the 705/705-4. |
| Which is faster on the road? | 25 km/h (15.5 mph)Traktorenlexikon, “Someca 850” | 30 km/h (18.6 mph)Traktorenlexikon, “Valmet 705” | AheadThe VALMET 705/705-4 has 20% more top speed (5.0 km/h / 3.1 mph) than the SOMECA 850 (TD) (both top speed forward, as stated by the source). |
| Which offers more PTO speeds? | — | 540 rpmTraktorenlexikon, “Valmet 705” | No figureNo call on PTO speeds: no standard PTO speed stated for the 850 (TD). |
| Which PTO runs independently of the ground drive? | — | independentTraktorenlexikon, “Valmet 705” | No figureNo call on PTO independence: not stated for the 850 (TD). |
| Which drives on both axles? | Two-wheel or four-wheel driveTraktorenlexikon, “Someca 850” | 2WD / 4WDTraktorenlexikon, “Valmet 705” | EvenEven on drive: every machine is available with four-wheel drive. |
| Which is newer, and what about parts? | 1969–1975 | 1983–1989 | Ahead (a fact, not an advantage)The VALMET 705/705-4 is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts. |
What does this mean in plain words?
- The VALMET 705/705-4 has 26% more hydraulic flow (10.0 L/min / 2.6 gpm) than the SOMECA 850 (TD) (both pump flow, as stated by the source).
- The VALMET 705/705-4 is 19% heavier (595 kg / 1,312 lb) than the SOMECA 850 (TD) (both unladen weight, as stated by the source).
- The VALMET 705/705-4 has 20% more top speed (5.0 km/h / 3.1 mph) than the SOMECA 850 (TD) (both top speed forward, as stated by the source).
- The VALMET 705/705-4 is newer: production began 14 years later. We hold no parts-availability data, so there is no call on parts.
- Even on power at the PTO shaft (both power at the PTO, claimed): the difference is under the 10% threshold for claimed figures, too small to call.
- Even on forward gears (both forward gears, as stated by the source): the figures vary by configuration and the ranges overlap.
- Even on drive: every machine is available with four-wheel drive.
- No figure on record for every machine, so no call on: fuel efficiency at the shaft, drawbar power, three-point lift, maximum permissible mass, a creeper range, PTO speeds and PTO independence.
← Every figure for both machines, side by side, with sources