5 material differences · fewer than 12
Tractor oneSOMECA 480 Special (TD)1977–1979No measured PTO figureTractor twoUTB U-5101979–1990No measured PTO figure
Which should you choose?
Read our verdict on the 480 Special (TD) and the U-510 → It is generated from the rows below by a fixed, versioned rule set, and names the figure behind every call.
Field by field
5 material differences · 7 fields identical or within 5%, which is not counted as material
| Field | 480 Special (TD) | U-510 | Gap |
|---|---|---|---|
| Engine | |||
| Engine power, claimed claimed | 47.3 hp | 47.3 hp | — |
| Engine declared | FIAT-IVECO 8035.02.200 (300) | UTB D-115.050 | differs |
| Displacement declared | 2.59 L | 2.70 L | — |
| Maximum torque declared | 112 lb·ft · 152 N·m | — | — |
| Transmission | |||
| Top speed declared | 15.5 mph · 25 km/h | 14.3 mph · 23 km/h | +9% 480 Special (TD) |
| Clutch declared | — | Dry LuK double clutch | — |
| Hydraulics & hitch | |||
| Pump flow declared | 5.8 gpm · 21.8 L/min | — | — |
| Pressure declared | 2,843 psi · 196 bar | — | — |
| Rear PTO speeds declared | 540 rpm | 540 rpm | — |
| Weight & dimensions | |||
| Unladen weight declared | 4,189 lb · 1,900 kg | 4,284 lb · 1,943 kg | — |
| Wheelbase declared | 76.9 in · 1,953 mm | 76.0 in · 1,930 mm | — |
| Length declared | 119.0 in · 3,023 mm | 116.5 in · 2,959 mm | — |
| Width declared | 65.4–89.3 in · 1,660–2,268 mm | 72.0 in · 1,830 mm | differs |
| Ground clearance declared | 14.6 in · 371 mm | 18.5 in · 470 mm | +27% U-510 |
| Turning radius, braked declared | 9.7 ft · 2.95 m | 9.1 ft · 2.77 m | +6% 480 Special (TD) |
| Fuel tank declared | 57.1 qt · 54.0 L | 57.1 qt · 54.0 L | — |
Height is not in this table. It is not one measurement: the sources measure it to different points — over the cab on some machines, over the steering wheel or the exhaust on others — and the same tractor measured two ways can differ by most of a metre. It appears here only when both machines' figures carry the point they were measured to and it is the same point, which is not the case for these two. Each machine's own page prints its height as its source gives it.
SOMECA 480 Special (TD) sources
- Source: Traktorenlexikon, “Someca 480 S”
- Source: Traktorenlexikon, “Fiat 480/480 DT”
UTB U-510 sources
- Source: Traktorenlexikon, “UTB U 510”
- Source: Traktorenlexikon, “UTB U 530”